Bosch B450 Specifications download pdf (Page 32)

ID Parameter Values Description

20 SMS Configuration 0 = Disabled

1 = Enabled

Allows the B450 to be configured via SMS

configuration.

65 IPv4 DNS Server IP

Address

IPv4 address format (0.0.0.0) The B450 uses the DNS server addresses supplied

by the cellular network when the Primary DNS

Server address option is configured as 0.0.0.0. If

the address is not configured as 0.0.0.0, the B450

installs the Primary DNS Server address.

66 Alternate IPv4 DNS

Server IP Address

IPv4 address format (0.0.0.0) If the address is not configured at 0.0.0.0, the B450

installs the Alternate DNS Server address.

67 Panel Programming

Enabled

0 = Disabled

1 = Enabled

Select to enable or disable control panel

programming. This enables/disabled configuration

of the B450 by the control panel.

68 Reporting Delay for

Low Signal

Strength

0 – 3600 sec. (1800) Sets the duration of time when the B450’s signal

strength is measured. The value selected

determines how long the signal strength must be at

a low condition before reporting as low, or how

long the signal strength must be normal before

reporting as normal.

69 Reporting Delay for

No Towers

0 – 3600 sec. (1800) Amount of delay before the module reports a

trouble for not being able to receive signals from a

cell tower.

70 Reporting Delay for

Single Tower

0 – 3600 sec. (0) Amount of time delay before module reports a

trouble due to getting signals from only one tower

instead of multiple towers.

71 Modem Reset

Count

0 – 99 communication attempts

(5)

This parameter determines how many times a

packet of data must be sent without a reply before

the cell module modem is reset to attempt

restoring communications.

72 TCP Keep Alive

Time

0 – 255 sec (45) This parameter determines how long to wait

between transmissions to keep an idle TCP

connection to a remote host from terminating due

to inactivity.

Table 5.5: SMS and USB configuration parameters

Short Message Service (SMS) configuration

The B450 supports configuration by SMS connection. The Short Message Service feature

allows an installer to configure the B450 through the use of a mobile phone, or any other

service that sends compatible SMS text messages.

Use SMS to configure the B450

The SMS string follows a specific format. If the configuration message exceeds 160

characters, you must send multiple messages. Refer to Compose the Configuration SMS for

more details.

When the B450 receives the final valid part of an SMS message, it accepts the configuration.

5.4

5.4.1

32 en | Configuration

Conettix Plug-in Communicator

Interface

2013.09 | 02 | F.01U.282.875 Installation and Operation Guide Bosch Security Systems, Inc.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 47 48

Comments to this Manuals

No comments

Bosch B450 Specifications Page 32

Comments to this Manuals

Related products and manuals for Security access control systems Bosch B450