Bosch B450 Specifications download pdf (Page 8)

B450 module overview

Figure 3.1: B450 Plug-in Communicator Interface

Callout ￚ Description

1 ￚ Tamper switch connector

2 ￚ Bus address switch

3 ￚ MODE 2-pin jumper connector (for future use)

4 ￚ Bus address label

5 ￚ USB connector (Type A)

6 ￚ Heartbeat LED

7 ￚ RX LED (indicates packets received from the wireless network)

8 ￚ TX LED (indicates packets transmitted over the wireless network)

9 ￚ Terminal strip (to control panel)

10 ￚ Interconnect wiring connectors (to control panel or other compatible modules)

Bus address settings

The address switch determines the bus address for the B450 Conettix Plug-in Communicator

Interface. The control panel uses the address for communications. Use a slotted screwdriver

to set the address switch.

Notice!

The B450 reads the bus address switch setting only during power up. If you change the

switch after you apply power to the module, you must cycle the power to the module in order

for the new bus address setting to be used for bus communication.

3.2

8 en | System overview

Conettix Plug-in Communicator

Interface

2013.09 | 02 | F.01U.282.875 Installation and Operation Guide Bosch Security Systems, Inc.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 47 48

No comments

Bosch B450 Specifications Page 8