Bosch INTEGRUS Service Manual download pdf (Page 31)

Integrus Installation | en 31

Bosch Security Systems B.V. Installation and Operation manual IOM-INT | V1.1 | 2010.12

4. Remove the analogue input/output PCB (2):

– Loosen the screws (3) between the cinch plugs on the rear panel (4). The number of

screws depends on the transmitter type.

– Loosen the screws (5) at the XLR connectors on the rear panel.

– Loosen the screws (6) of the distance studs (7) of the analogue input/output PCB.

Do not lose the (spring) washers (8).

– On the main PCB (9) detach the flexible cables(10) to the analogue input/output

PCB. To this end release the catches (11) on both sides and pull out the flexible

cable. See inset in Figure 5.4.

– Remove the analogue input/output PCB.

5. Remove three distance studs (7A, 7B and 7C) of the analogue input/output PCB.

6. On the main PCB (9):

– Detach the user interface cable (12).

– Detach the power supply connector (13).

– Loosen the screws (14) of the distance studs. Do not lose the (spring) washers (15).

7. Remove the main PCB.

5.3.2 Installation of the INTK

Follow the instructions below to install the INT-TXK. The numbers refer to Figure 5.6 and

Figure 5.7.

Figure 5.6 Installation of the INT-TXK (steps 1 - 6)

5B 5A

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 89 90

No comments

Bosch INTEGRUS Service Manual Page 31