Bosch INTEGRUS Service Manual download pdf (Page 51)

Integrus Configuration | en 51

Bosch Security Systems B.V. Installation and Operation manual IOM-INT | V1.1 | 2010.12

* Note that after selecting ‘Stereo’ as input mode (step 14) the input number changes

automatically to the next even number (12), which is the input number of the left signal.

7.2 Setup the transmitter

The next sections give descriptions of the possible setup options. Each description is

followed by the relevant menu items with detailed information per menu option. The default

values (see section 7.2.14 ) are indicated by an asterisk (*) when applicable.

7.2.1 Main menu

The main menu contains the screens to the operational menus (see section 9.1 ) and to the

Setup sub-menu (see sections 7.2.2 and higher).

7.2.2 Set transmission mode

The Transmission Mode menu item (4A) is used to select which signals will be distributed

over the channels. It is also possible to switch all channels off (Standby). When using an

Integrus system with a DCN Next Generation system (see section 7.2.3 ), the transmitter is

automatically switched to 'Standby' when the connected DCN Next Generation system is

switched off. When the DCN Next Generation system is switched on, the transmitter is

automatically switched to 'On'. When using an Integrus DCN interface module of version 01.05

or higher, the transmitter is automatically switched to 'Standby' when the connected DCN

system is switched off. When the DCN system is switched on, the transmitter is automatically

switched to 'On'.

22. Push to confirm.

23. Ready.

Menu Item Description

Transmitter Status Shows the transmitter status (see section 9.1.2 )

1 Fault Status Shows the radiator fault status (see section 9.1.3 )

2 Monitoring . . . Go to the ‘Monitoring’ sub-menu (see section 9.1.4 )

3 Enquiry . . . Go to the ‘Enquiry’ sub-menu (see section 9.1.5 )

4 Setup . . . Go to the ‘Setup’ sub-menu (see sections 7.2.2 and higher)

Menu Item Options Description

4A Transmission Mode:

- Standby All channels are switched off, no signals are

distributed.

* - On Normal transmission. Input signals are

distributed on the channels as set in the

Channel Quality sub-menu (4D).

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 89 90

No comments

Bosch INTEGRUS Service Manual Page 51