Bosch F220 User Manual download pdf (Page 3)

F220 Series Detectors with F220-B6RS Bases General Information | en 3

Bosch Security Systems, Inc. Installation Manual F.01U.029.847 | -01 | 2007.02

use a can of clean, dry compressed air (such as TECHSPRAY

ENVI-RO-TECH Duster) which is available at office and alarm

supply stores. Shorten the plastic tube that comes with the

compressed air to about 2 in. (5 cm). Place the tube or needle

valve through the Chambermaid valve in the bottom of the

detector (refer to Figure 2.2 on page 6).

2 General Information

This document covers mounting, wiring, power requirements,

testing, and maintenance for the F220-B6RS Detector Bases

and the F220 Series Heat and Photoelectric Smoke Detectors.

Install them according to NFPA 72.

For installation guidelines, refer to Installation Considerations

for Smoke and Fire Detectors (P/N: 26715).

2.1 F220-B6RS Detector Bases

The F220-B6RS is a four-wire base with a Form A alarm relay

and a built-in sounder. Other bases (two-wire and four-wire

without built-in sounders) are available. Refer also to the F220

Series Detectors with F220-B6/C/E/R Installation Instructions

(P/N: 4998138694) and the F220-B6PS/M Installation

Instructions (P/N: 4998149982).

2.1.1 Compatible Control Panels

The F220-B6RS is a four-wire base compatible with all UL Listed

four-wire control panels. Refer to the control panel

NOTE! Do not paint the detectors. Paint or other foreign

matter covering the detector can prevent smoke

detection.

NOTE! For proper system installation, read and

understand NFPA 72 before installation.

F01U029847-01.book Page 3 Thursday, March 1, 2007 9:27 AM

1 2 3 4 5 6 7 8 ... 27 28

No comments

Bosch F220 User Manual Page 3