Bosch ITS-DX4020-G Specifications download pdf (Page 18)

18 en | Configuration GPRS/GSM IP Communicator

F01U133268 | 03 | 2010.05 Installation and Operation Guide Bosch Security Systems, Inc.

4 Configuration

The ITS-DX4020-G supports configuration by either SMS or USB connection. You can

configure up to two different modes, depending on the control panel. For a list of modes

allowed by the different control panels, refer to Table 4.1, Page 22.

Table 4.1 Modes Allowed by Control Panel

4.1 Use Short Message Service (SMS) to Configure the

ITS-DX4020-G

The ITS-DX4020-G supports configuration by SMS. You can send the SMS via mobile phone to

the ITS-DX4020-G. The SMS string follows a specific format. If the configuration message

exceeds 160 characters, you must send multiple messages. Refer to Section 4.1.2 Compose

the Configuration SMS, page 19 for details.

When the ITS-DX4020-G receives the final valid part of an SMS message, it accepts the

configuration. The ITS-DX4020-G waits as long as the CONFIG MODE jumpers are shorted

together with the supplied jumper plug.

4.1.1 Enter CONFIG MODE

Ensure that the CONFIG MODE jumper pins are shorted together with the supplied jumper

plug. The STATUS, CELL IP, and AUDIO ACT LEDs start a scrolling pattern.

Control Panel GPRS (IP) PSTN (Contact ID)

over GSM

DUAL

Easy Series

DS7240V2 Series

DS7400xiV4

FPD-7024

GV2 Series

GV3 Series

NOTICE!

When using the PSTN (Contact ID) over GSM mode on a GV3 Series control panel, ensure that

the “C” character is dialed before the central station’s phone number. The "C" character

disables dial tone detection after the first DTMF digit is dialed.

NOTICE!

Bosch recommends that when using GSM mode, always enter a 10-digit phone number in the

control panel. This is because the SIM card might have originated in a different area code from

the installation location.

NOTICE!

When using the PSTN (Contact ID) over GSM mode, the control panel must be set up for

DTMF (tone) dialing only.

NOTICE!

To allow the receipt of SMS data, the CONFIG MODE jumper pins must be shorted together

with the supplied jumper plug. Refer to Table 4.6, Page 21, for LED activity.

If the CONFIG MODE jumper pins are not shorted together, incoming SMS data is discarded.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 51 52

No comments

Bosch ITS-DX4020-G Specifications Page 18