Bosch ITS-DX4020-G Specifications download pdf (Page 25)

GPRS/GSM IP Communicator Configuration | en 25

Bosch Security Systems, Inc. Installation and Operation Guide F01U133268 | 03 | 2010.05

4.2.3 Log Into the USB Interface

1. Ensure that the USB-to-mini-USB cable is connected to the ITS-DX4020-G and the target

PC or laptop.

2. Short the CONFIG MODE jumper pins with the supplied jumper plug.

3. From Windows, start a terminal session by doing one of the following:

– If you are using Windows XP or earlier, launch Hyper Terminal by selecting Start>(All)

Programs>Accessories>Communications>Hyper Terminal.

– In you are using Windows Vista or Windows 7, launch Tera Term by selecting Start>(All)

Programs>Tera Term>Tera Term.

4. Set up a connection on the new virtual serial COM port (for example, Port: COM4:

ITS-DX4020-G [COM4]) using the following settings:

– Baud rate: 9600

– Data bits: 8

– Parity: None

– Stop bits: 1

– Flow control: None

To determine which COM port is used by the ITS-DX4020-G:

a. From your desktop, click Start.

b. Right-click My Computer, and select Properties.

c. Select the Hardware tab, and click the Device Manager button.

d. In the Device Manager list, scroll to Ports (COM & LPT).

e. Open the Ports (COM & LPT) node.

If the ITS-DX4020-G is connected to the computer, it appears in this list with its

COM port assignment next to it.

If the ITS-DX4020-G is not connected to the computer, or the USB driver is not

installed, the ITS-DX4020-G does not appear in this list.

5. After the connection is established, press [Enter].

The ITS-DX4020-G USB login window opens.

NOTICE!

To allow for USB configuration, the CONFIG MODE jumper pins must be shorted together with

the supplied jumper plug. Refer to Table 4.6, Page 21, for LED activity.

If the CONFIG MODE jumper pins are not shorted together, you can only view configuration

data.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 51 52

No comments

Bosch ITS-DX4020-G Specifications Page 25