12 en | Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts AutoDome Modular Camera System
F01U010921 | 1.0 | 2006.10 Installation Manual Bosch Security Systems, Inc.
6. To connect alarm inputs and relay outputs, connect the 4-pin Alarms Out, the 6-pin
Alarms In and the 7-pin Relay connectors from the Pendant Connector Harness to their
mating connectors, installed previously, to the incoming alarm wires.
7. Connect the 3-pin Power In Plug, installed previously, to its matting connector P101 on
the left side of the box.
8. If installing a Fiber Optic model attach the incoming ST fiber plug, installed previously, to
its mating connector on the Fiber Optic Module in the power supply box. Then attach the
video BNC plug to its mating connector from the Pendant Connector Harness. See
Chapter 4: Cable and Wire Standards for fiber optic specifications.
Fig. 1.9 Optional Fiber Optic Module
9. If using UTP for video or Ethernet, connect the incoming RJ45 video connector, installed
previously, to its mating connector from the Pendant Connector Harness. See Chapter 4:
Cable and Wire Standards for connections and specifications.
10. After making the harness connections to the Power Supply Box, rotate the Pendant Arm
to close and seal the Power Supply Box and tighten the two (2) captive screws to
10-12 N-m (90-105 in.-lbs).
(GND
POWER IN DATA IN/OUT
IN/OU
IN/OU
GND TXD
RXD
C+
C-
(TRANSFORMER)
FUSE)
FUSE)
FUSE
LINE N
NE
T
BNC TO DOME
ST CONNECTOR
(FIBER)
FROM ARM
HARNESS
IN/OUT
IN/OUT
Power In
Data IN/OUT
Comments to this Manuals