Bosch AutoDome Installation Manual download pdf (Page 59)

AutoDome Modular Camera System Installing the In-Ceiling Mount | en 49

Bosch Security Systems, Inc. Installation Manual F01U010921 | 1.0 | 2006.10

3.10 Attach Bubble

The Dome Bubble/trim assembly attaches to the In-Ceiling Housing.

1. Place the bubble over the Camera Module, and align it until it settles.

2. Rotate the bubble clockwise until it locks in position. See Figure 3.13 on page 48.

Fig. 3.14 In-Ceiling Bubble

Bubble Removal

To service the In-Ceiling AutoDome, use the following procedure to remove the Bubble:

1. Loosen the lockscrew in the trim ring using a P1 or smaller Phillips screwdriver until the

bubble can rotate freely.

2. Then rotate the bubble counterclockwise approximately 1/4 turn until it releases from

the In-Ceiling Housing. See the figure below for an illustration.

Fig. 3.15 Bubble Release Screw

NOTICE! The dome bubble comes assembled with a white trim ring. An optional black trim

ring is supplied separately. To replace the white trim ring, remove the four (4) Phillips head

screws from the inner ring and remove the white trim ring. Then place the black trim ring over

the inner ring, and replace and tighten the four (4) screws.

In-Ceiling

Housing

Camera Module

Bubble

Ceiling

In-ceiling

Housing

Ceiling

Camera Module

Bubble

LOCK SCREW

Lockscrew

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 83 84

No comments

Bosch AutoDome Installation Manual Page 59