Bosch EnviroDome Installation Manual download pdf (Page 9)

1.6 Attach the installation-assist cable* to the eyehook on the

top of the dome, and close the safety cable (see PHOTO

1F).

* A cable (user-provided) is recommended for safety

purposes when pipe mounting. See Mounting Guide for

instructions.

Photo 1F Connections

1.7 MAKE THE FOLLOWING CONNECTIONS:

**If the AutoDome is programmed for RS-485 operation, RXD

functions as DATA (+), and TXD functions as DATA (–).

Figure 1B Control connector

a. If the Alarm Inputs or the Relay Output are being

used, connect the appropriate wires to the 8-pin Alarm

connector (see FIGURE 1C).

Figure 1C Alarm connector

b. Connect Video (BNC) cable and the CONTROL

connector. Tighten screws on control connector.

c. When using Biphase, and the dome is in a star

configuration (or is the last dome on a daisy chain), it

requires a 110 Ω terminating resistor (included) across

pin 8 (C+) and pin 9 (C–).

Daisy chain configuration is not possible if fiber optic

accessory is used.

1.8 AUTODOME 24 VAC INSTRUCTIONS

ENVX2450X, ENVX2460X, G3AX5X, and G3AX6X Kits

Check for the following:

a. An ENV-PSU (or equivalent) power supply must be

used.

b. Be sure to use an adequate gauge of 24 VAC wiring for

the distance run. See APPENDIX A - Power Wiring

Guide for proper wiring instructions and recommended

wire run lengths.

c. Wire the 9-pin CONTROL connector located on the

top of the unit, as in STEP 1G.

d. If the Alarm Inputs or Relay Output are being used,

connect the appropriate wires to the 8-pin Alarm

connector.

Figure 1D

If not using an ENV-PSU, place a jumper between

Pin (1) 24 VAC Hot and Pin (3) Heater (see

APPENDIX A for details).

1.9 Align the notch on the AutoDome with the notch on the

FRONT of the Pendant Arm.

Section 1

GND A1 A2 A3 A4 NC COM NO

87654321

ALARM CONNECTOR

ALARM GROUND

ALARM INPUT #1

ALARM INPUT #2

ALARM INPUT #3

NORMALLY OPEN

RETAINING SCREW

RELAY COMMON

NORMALLY CLOSED

ALARM INPUT #4

C–

Biphase

Ground

Biphase +

Biphase –

RS-232

Ground

**RS-232 TX

**RS-232 RX

24 VAC Neutral

Indoor Pendant - Not Connected

EnviroDome

- 24 VAC Heater

24 VAC Hot

C+ GND RXD TXD GND H

24 VAC

9 87654321

CONTROL CONNECTOR

Retaining

Screw

BNC Connector

Eyehook

8-Pin Alarm

Connector

9-Pin Control

Connector

Installation Assist Cable

**EnviroDome Only

Top of Dome

(1) 24 VAC Hot

(2) 24 VAC Neutral

(3) Heater**

(4) RS-232 Ground

(5) RS-232 TXD

(6) RS-232 RXD

(7) Biphase Ground

(8) Biphase +

(9) Biphase –

To ENV-PSU

equivalent

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 39 40

Comments to this Manuals

No comments

Bosch EnviroDome Installation Manual Page 9

Comments to this Manuals

Related products and manuals for Bridge cameras Bosch EnviroDome