Bosch PCR915B91A Operations Instructions download pdf (Page 8)

Installation of cooktop

into the kitchen bench

Installation procedure:

Side clearances: If the distance measured from the

periphery of the nearest burner to any vertical surface is

less than 200 mm, the surface shall be protected in

accordance with clauses 6.10.1.2 of AS/NZS 5601.1

1. For cutout dimensions and clearances refer Fig.1.

2. The clips and the adhesive seal (underside of the

cooktop) are already fitted (depending on the model), do

not under any circumstances remove them. The seal

ensures that the entire work surface will be watertight,

and prevents water seepage. In order to fit the appliance

into the kitchen unit, first place the cooktop in the correct

position then loosen each of the clips so that they all turn

freely (it is not necessary to completely undo them).

Insert and centre the cooktop.

Press the sides of the cooktop until it is supported around

its entire perimeter.

Turn the clips and tighten them fully. Fig. 3.

Connection

Electrical An electrical 10 amp socket needs to be within 1 m of the

hotplate to allow electrical connection. The socket must

remain accessible after installation of the appliance.

Important note:

This appliance is connected to the mains (240 VAC) by

means of the connecting lead which must be fixed to the

kit ch en uni t t o pr ev ent it from c omi ng int o c ont ac t w it h ho t

parts of the cooktop (or an oven installed underneath)

and remain accessible after installation of the cooktop.

When making this connection make sure that the lead

cannot come into contact with hot parts of the cooktop.

Important: This appliance must be earthed. When

connecting the cooktop ensure that the earth wire is

connected first and that all wires are connected to the

correct terminals. Fig. 4.

Gas

During the planning stage, consider the position of supply

connections.

Fig. 3.

Fig. 4

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 20 21

No comments

Bosch PCR915B91A Operations Instructions Page 8