Bosch 5412L Operations Instructions download pdf (Page 11)

Assembly

Installation And Removal Of The Blade

Disconnect plug from power source

before performing any assembly,

adjustment or repair to avoid possible injury.

1. The miter saw is equipped with a lock pin used to

lock the miter saw in the lower position. To release,

push the handle down slightly and pull the lock pin

to its full out position and rotate 90° .

NOTE:If the lock pin is stuck and will not pull out

when the handle is pushed down slightly, you may

have to adjust the depth stop bolt (see Depth

Adjustment, page 16) slightly so the handle can be

pushed down and the lock pin can be pulled out.

2. Rotate the lower guard by hand. Loosen front

cover screw to a point that cover plate can be lift-

ed (Figure 1).

3. Rotate the cover plate counterclockwise so the

blade bolt is exposed (Figure 1).

4. Press and hold the arbor lock (See figure on page

9). Use the multi purpose tool to remove the blade

bolt by turning wrench clockwise. NOTE: The

blade bolt has left hand threading.

Lower Guard

Outer Washer

Blade Bolt

(Left Hand Thread)

Sawblade

Inner Washer

Figure 2. Blade Hardware

6. To install the 12" blade, fit blade between the chip

deflectors and onto the arbor shaft, and onto 1"

support ring on the inner washer (Figure 3).

NOTE: Make sure the rotation arrow on the blade

matches the clockwise rotation arrow on the lower

guard.

Cover Plate

Front

Cover

Plate

Screw

__ Inner

Washer

Rear Cover Upper Blade Outer

Plate Screw Guard Bolt Washer

Upper

Guard

Arbor

Shaft

Figure 3. Blade Installation

Figure 1. Blade Removal

5. Remove the blade bolt, outer washer and the

blade. Inner washer does not need to be removed

(Figure 2).

and 1" arbor.

To avoid injury, do not use a blade

larger or smaller than 12" diameter

7. Replace the outer washer in it's proper orientation,

and tighten blade bolt finger tight. Press the arbor

lock and tighten blade bolt securely using multi

purpose tool, but do not overtighten.

8. Rotate cover plate clockwise to original position.

Tighten the front cover plate screw.

11.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 111 112

Comments to this Manuals

No comments

Bosch 5412L Operations Instructions Page 11

Comments to this Manuals

Related products and manuals for Mitre saws Bosch 5412L