Bosch 5412L Operations Instructions download pdf (Page 15)

Adjustments

Blade Square to Fence

1. Make sure head assembly is pushed forward

near the center of the table and slide rail lock

knob is tightened.

2. Lower the head assembly, pull the lock pin out and

rotate it 90° , rotate to lock the head assembly in the

down position. Make sure table is in 0°

detent and tighten miter lock knob. Place a com-

bination square against the fence and next to the

blade as illustrated. Locate the square properly

so it does not contact the tooth of saw blade.

The saw blade should contact the full length of

the square (Figure 9).

3. If blade does not contact the square, follow the

fence alignment procedure.

Blade

Combination Square

Fence alignment

a. Remove sliding fence extensions.

b. The head assembly should remain in lowered

position.

c. Use multi purpose wrench (supplied) and

loosen four (4) hex bolts behind fence

(Figure 10).

d. Adjust fence until blade and the fence has full

contact with the square.

e. Tighten hex bolts.

f. Re-attach sliding fence.

Hex Bolts

Figure 10. Fence Adjustment

Figure 9. Blade Square to Fence

Miter Scale

Indicator Adjustment

1. Rotate table to 0° position and lock in place.

2. Raise the head assembly to the full-up position.

3. Loosen the Phillips screw that holds the indicator

in place (Figure 11).

4. Position the indicator to align with the 0° miter

mark. Tighten the screw.

Indicator

ustment

Screw

0° Mark

Miter Scale

Indicator

Figure 11. Miter Scale Adjustment

15.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 111 112

Comments to this Manuals

No comments

Bosch 5412L Operations Instructions Page 15

Comments to this Manuals

Related products and manuals for Mitre saws Bosch 5412L