Bosch 5412L Operations Instructions download pdf (Page 22)

Basic Saw Operations

Miter Detent Override

The miter detent override feature allows the detent

action to be locked out, allowing for micro adjust-

ments at any miter angle. When the desired miter

angle is to close to a standard mitering angle that has

a detent slot, this feature prevents the wedge on the

miter arm from slipping into the detent slot on the

base.

1. Lift and hold the miter detent lever (under base

arm).

2. Push the detent override clip forward and latch in

place over edge. Release miter detent lever

(Figure 24).

3. Move miter arm to any position on the miter scale.

4. Lock the miter lock knob to retain miter position.

To Disengage:

5. Loosen miter lock knob and lift the miter detent

lever to release the detent override clip. The clip

should automatically disengage and the table

should lock into any desired miter detent.

Clip

Detent

Override Clip

Miter Miter

Detent Lever Lock Knob

Figure 24. Detent Override

Sliding Fences and Base Extensions

So as to provide sufficient (mini-

mum 6") spacing from hand to saw

blade, extend the sliding fences and base extensions

when making extreme bevel, miter or compound

cuts.

The base extensions can also be used to provide

extra support for long workpieces.

Sliding Base:

1. Loosen the base extension clamping levers

(Figure 25).

2. Extend sliding base extensions to the desired

position.

3. Press the levers down to clamp the extensions

into place.

Sliding Fence:

1. Loosen the fence locking knobs (behind fence).

2. Slide fence to proper position.

3. Tighten knobs to lock fence into place.

To Temporarily Remove Sliding Fence:

Some extreme compound angles make it necessary

to remove one of the sliding fences.

1. Unscrew fence knob until at least 1/2" of thread

shows.

2. Slide fence to its centermost position.

3. Lift fence to remove.

4. Tighten knob

After the cut is complete, reinstall the sliding fence.

To reinstall the sliding fence, reverse this procedure.

During transportation, sliding base

extensions and fences should

always be secured in the fully closed position.

Base Extensions

Clamping levers

Figure 25. Sliding Fences and Base Extensions

See page 20 for information about other types of

workpiece support.

22.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 111 112

Comments to this Manuals

No comments

Bosch 5412L Operations Instructions Page 22

Comments to this Manuals

Related products and manuals for Mitre saws Bosch 5412L