Bosch DVA-12T Installation Manual Page 22

  • Download
  • Add to my manuals
  • Print
  • Page
    / 72
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 21
22 en | Hardware Installation RAID Subsystem DVA-16K | Installation Manual
F.01U.027.799 | V2 | 2008.08 Bosch Security System
3.6 Rack/Cabinet Installation
The RAID subsystem has been designed to fit into a standard cabinet or rack. Two (2) slide
rails are available for installing the subsystem into a rack or cabinet. Please contact your sys-
tem vendor for further details. The subsystem should be installed in the rack or cabinet before
the hard drives and the drive trays are installed. If the drive trays with the associated hard
drives are installed, the subsystem will be too heavy to mount into a rack or cabinet. When
installing the subsystem into a rack or cabinet it is advisable that three people assist in the
mounting process.
To install the subsystem into a rack or cabinet please refer to the installation instructions that
came with the slide rails.
3.7 Drive Tray Installation
Once the hard drives have been installed in the drive trays, the drive trays can be installed into
the RAID subsystem.
1. Make sure the key-lock is in the unlocked position, i.e., the groove on its face is in a hori-
zontal orientation. If the groove is in a vertical position, as shown in Figure 3.1, then the
key-lock is locked and the front flap on the drive tray cannot be opened.
Fig. 3.1 Front View of an Individual Drive Tray
2. Open the front flap on the drive tray. (See Figure 3.2) Push the button on the front of the
drive tray. The front flap will open in an upward direction.
Fig. 3.2 Drive Tray Front Flap
3. Align the drive tray with the slot in which you wish to insert it. Make sure that it is resting
on the rails inside the enclosure. Once the drive tray is lined up with the slot, gently slide
it in. This should be done smoothly and gently. (See Figure 3.3)
CAUTION!
All drive trays must be installed into the enclosure even if they do not contain a hard drive. If
the trays are not installed into the enclosure, the ventilation required for cooling will not be
normalized and the subsystem will overheat.
Page view 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 71 72

Comments to this Manuals

No comments