Bosch DVA-12T Installation Manual download pdf (Page 51)

RAID Subsystem DVA-16K | Installation Manual Subsystem Maintenance | en 51

Bosch Security System F.01U.027.799 | V2 | 2008.08

Fig. 6.11 Power Sockets and Power Switches

3. Remove the PSU retention screw at the top right-hand side of the PSU. (See Figure 6.12)

Fig. 6.12 Removing the PSU Retention Screw

4. Remove the PSU module by pressing down the PSU handle found on the top of the PSU.

(See Figure 6.13) This will dislodge the PSU module from the subsystem.

Fig. 6.13 Pressing Down the PSU Handle

5. After the PSU module has been dislodged from the enclosure, use the handle to gently

pull the PSU module out of the enclosure. (See Figure 6.14)

Fig. 6.14 Dislodging the PSU

6. Remove the cooling module from the lower level of the PSU module. Please refer to

Section 6.6 Cooling Module Maintenance.

Power Socket

Power Switch

PSU Handle

CAUTION!

• When a PSU is pulled out of the chassis, the cooling module beneath the PSU is removed

from the chassis at the same time.

• It is recommended that the replacement procedure is completed in less than five (5) min-

utes to prevent the subsystem from overheating.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 71 72

No comments

Bosch DVA-12T Installation Manual Page 51