Bosch Rextroth TSplus Service Manual download pdf (Page 16)

Bosch Rexroth Corporation

R980 500 388 (6.2010) TSplus Carousel Basic Equipment Guide

NOTE: For reasons of safety, as well

as to avoid damage to the equipment,

all steps in the assembly of the

conveyor section should be performed

by at least two technicians. Always lift

heavy parts with the appropriate tools

or assistance.

Assembly sequence:

1. Carefully place the conveyor

drive module where you

expect the drive to be

located (See Fig. 16 on

Page 17).

2. Remove top & inside covers

(Fig. 13). To do this, simply

loosen the socket head cap

screws and T-nut fastening

the inside and top cover

using a metric hex wrench.

3. Secure lifting strap(s)

sling(s) over the two cross

links (Fig. 14) and use a

hoist to lift the module off

the ﬂoor. Raise the module

slightly higher then the leg

set SZ2/CAR.

Fitting Leg Sets to the Carousel Drive Module

Fig. 13

Fig. 14

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 33 34

No comments

Bosch Rextroth TSplus Service Manual Page 16