Bosch Rextroth TSplus Service Manual download pdf (Page 22)

Bosch Rexroth Corporation

R980 500 388 (6.2010) TSplus Carousel Basic Equipment Guide

Align the conveyor

Check to see whether the leg sets

supporting the straight sections of the

conveyor are exactly in line.

NOTE: Always re-check the crosswise

alignment after making adjustments to

the leveling feet for lengthwise align-

ment and vice versa.

1. First check visually for

straightness; then attach

a T-bolt to the leg sets at

each end of the conveyor’s

straight sections and run

an alignment cord from end

to end, as shown in Fig. 21

and 22.

2. Make sure that the cord

is taut and that the space

between the cord and each

leg set is identical. If the

leg sets are not exactly in

line, push them into place.

Repeat the procedure

for all of the conveyor’s

contiguous straight

sections.

IMPORTANT!

Failure to ensure straightness will

result in premature wear and chain

failure.

Level the conveyor

The conveyor should be checked

from side to side and end to end

to make sure that it is level along

its entire length. Adjust the level-

ing feet as needed to make sure it

is level.

NOTE: Large conveyor systems can be

leveled more easily with a transit.

SECTION A-A

Alignment cord

Alignment Cord

T-bolt

Measure Here

Leveling and Aligning the Conveyor

Fig. 21

Fig. 22

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 33 34

Comments to this Manuals

No comments

Bosch Rextroth TSplus Service Manual Page 22

Comments to this Manuals

Related products and manuals for Straight grinders Bosch Rextroth TSplus