Bosch D6100IPv6 Specifications download pdf (Page 38)

Clear Pending Events (Function 4)

Use this option to clear all pending events.

Running the Clear Pending Events function:

1. Press the Function key. Enter your password and press the Enter key to go to the

Welcome Manager.

2. Press [4] and Enter.

3. Press [0] to cancel the function and not delete all pending events, or press [1] to clear all

pending events.

LCD/LED Availability Test (Function 5)

Use this option to clear all pending events.

Running the LCD/LED Availability Test function:

1. Press the Function key. Enter your password and press the Enter key to go to the

Welcome Manager.

2. Press [6] and Enter.

The LCD changes all segments to black for 2 sec so that you can check for nonfunctioning LCD

segments. All D6641 Line Cards turn the line LEDs on red for 2 sec and then green for 2 sec.

The Power and System trouble LEDs turn on for 2 sec, then off. After the test completes, the

system restores the LEDs to their previous state.

Busy Seconds (Line Busy) Reports

The D6600/D6100IPv6 monitors and reports when a call group of receiver lines cannot receive

signals. The receiver cannot process signals if its incoming telephone lines are in trouble, if

other communicators have the line tied up, or if the line card is inoperative. The receiver

interprets telephone lines that are not in trouble and taking calls as busy time. Telephone lines

that are in trouble are not included in the busy time calculation.

The amount of busy time accumulated during a 10 min period is the basis for a Busy Seconds

Reports. The 10 min busy period begins when all lines in a call group become busy, or when a

non-programmed single line for a call group becomes busy. The D6600/D6100IPv6 totals the

accumulated busy time and prints the Busy Seconds Report after the 10 min period ends.

After at least 60 sec (10%) of busy time, the receiver generates a report. The D6600/

D6100IPv6 reports up to 100% busy time.

Program the Busy Seconds Reports option to No if Busy Seconds Reports are not wanted for

all lines. Setting the Line Sniff option to 2 disables reports for individual lines.

Notice!

Enable Seconds Reports for UL Listed central stations.

UL inspectors might investigate the amount of time the digital receiver lines cannot receive

signals. Ensure that lines are available to process emergency signals on a timely basis.

Excessive Line Busy Reports can indicate it is necessary to install additional lines in rotary

with your primary receiver lines.

Assign each line to a call group. For the group to start accumulating busy time, all lines in the

call group must be online, in trouble, or without an operating line card.

11.5

38 en | D6600/D6100IPv6 Operation

Conettix Communications Receiver/

Gateway

2012.11 | 08 | 4998122704 Installation and Operation Guide Bosch Security Systems, Inc.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 87 88

Comments to this Manuals

No comments

Bosch D6100IPv6 Specifications Page 38

Comments to this Manuals