Bosch D6100IPv6 Specifications download pdf (Page 40)

When the Hold option is set for 1 to 99 sec, the line card remains off-hook for the

programmed hold after sending the audio event signal to the automation firmware, allowing

the firmware controlled PBX to pick up the line. Then it hangs up.

Enhancements and Changes

– Setting TWA by the selected Alarm Code allows one or multiple Alarm Codes to be

selected. TWA works with 10 to 40 baud Pulse formats, DTMF 4/1, 4/2, 4/3 and Contact

ID formats

– Setting TWA by the selected zone number allows the selection of one or multiple zone

numbers. TWA works with 10 to 40 baud formats and DTMF 4/1, 4/2 and 4/3 formats.

The zone number is the last digit of events that activates the TWA function

– TWA by combined conditions includes the account number, alarm code, and zone

number.

– Supports TWA auto-entered by more events and in various protocols, including Contact ID

Event Code 606, and SIA control blocks.

When the line card is in Two-Way Audio Mode, it goes on-hook only when the operator presses

Cancel, or the automation firmware issues a Stop Listening Command !Knn<CR>, where nn is

the physical line number.

Notice!

The maximum online time during two audio sessions is disabled.

The line card’s listen-in duration settings override the control panel’s listen-in duration set-

tings

When pressing Cancel during the two-way audio session, the receiver prompts the operator to

enter the line number for stopping the two-way audio. Ensure that the D6600/D6100IPv6 is

not in Menu Mode during this operation.

The OL/LF LED flashes green during the audio session.

The D6600/D6100IPv6 prints the audio status on the printer with the physical line number and

sends the audio status to the automation firmware with the physical line number.

The D6600/D6100IPv6 decodes the first digit of the account number to determine when to

start two-way audio operation. If the first digit of the account number matches the selection,

two-way audio activates.

Two-Way Auto Modes of Operation

– Transfer. D6600/D6100IPv6 transfers the incoming line to another line; a flash operation

occurs at the end of the alarm signal. The receiver dials the line programmed at Transfer

Phone Number. (Refer to Menu Items 3.1.4.18 Flash [x 100ms] and 3.1.4.19 Transfer Phone

Number in the D6600/D6100IPv6Program Entry Guide (P/N: 4998122702)).

– Hold. The D6600/D6100IPv6 remains off-hook as programmed so another device can take

over the line before hold time expires. (Refer to Menu Item 3.1.4.20 Hold in the D6600/

D6100IPv6 Program Entry Guide (P/N: 4998122702)).

– Duration. The D6600/D6100IPv6 remains off-hook as programmed or until terminated by

a Stop command. Connect a regular telephone in parallel with the incoming telephone

line. (Refer to Menu Item 3.1.4.1 Duration in the D6600/D6100IPv6 Program Entry Guide

(P/N: (4998122702)).

Notice!

The D6600/D6100IPv6 can perform only one of these operations at a time. If there is more

than one, the sequence is Transfer, Hold, and Duration.

11.6.1

11.6.2

40 en | D6600/D6100IPv6 Operation

Conettix Communications Receiver/

Gateway

2012.11 | 08 | 4998122704 Installation and Operation Guide Bosch Security Systems, Inc.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 87 88

Comments to this Manuals

No comments

Bosch D6100IPv6 Specifications Page 40

Comments to this Manuals