Bosch GTA 3800 Professional User Manual download pdf (Page 19)

English | 19

Bosch Power Tools 1 609 929 U17 | (4/8/10)

Assembly

Delivery Scope

Please also observe the represen-

tation of the delivery scope at the

beginning of the operating instruc-

tions.

Before assembling the saw stand, check if all

parts listed below are provided:

Additionally required tools (not in delivery

scope):

– Open-end spanner (10 mm)

Assembling the Saw Stand

– Carefully remove all parts included in the de-

livery from their packaging.

– Remove all packaging material.

Setting Up the Saw Stand (see figures A1 – A2)

– Lay the saw stand upside down on the floor

(legs facing upward).

– Push the locking pin 15 in and tilt the leg up-

ward until the locking pin can be heard to en-

gage.

– Repeat this workstep with the other three

legs.

– Turn around the saw stand to the working

position.

– Ensure that the saw stand is stable and that

all locking pins have engaged.

The saw stand is easily aligned with the height-

adjustable leg 9.

– Screw the leg in or out until the saw stand is

aligned level and all four legs face against the

floor.

Mounting the Roller Stand (see figure B1)

– Unscrew the Phillips screw of the roller

stand 7 with the Phillips screwdriver 14 pro-

vided.

If required, counter-hold the lock nut on the

other side of the roller stand using a spanner

(size 10 mm).

– Disassemble the roller stand 7.

There are different possibilities to arrange the

individual rollers to the workpiece support with

the internally-threaded rod (see figure).

– Arrange the individual parts as required and

slide the internally-threaded rod through the

rollers and the workpiece support 1.

– Screw all parts together again.

Mounting the Workpiece Support

(see figure B2)

– Loosen the locking knobs 3 and pull the table

extensions 2 via both sides of the saw stand

lightly outward.

– Slide the workpiece supports 1 from the left

and right each into the upper groove of the

saw stand or the table extension.

The length stops 8 must face outward.

– Tighten the locking knob 6 to lock the work-

piece support.

Preparing the Saw Stand

Preparing the Attachment Sets

(see figures C1 – C4)

– To release the attachment sets 4, press but-

tons 16 each and open the levers 17.

– Measure the distance x between the mount-

ing holes and your power tool.

– Position the attachment sets 4 centred on

the saw stand and at the matching clearance

x to each other.

–Lock the levers 17 again. The attachment

sets are now firmly positioned on the saw

stand.

No. Designation Quantity

Saw stand GTA 3800 1

4

Attachment set 2

1

Workpiece support 2

7

Roller stand 2

14

Socket spanner/Allen key/

Phillips screwdriver 1

19

Power tool fastening kit

consisting of:

– Hexagon bolt

(M8 x 45)

– Washer

4

4

OBJ_BUCH-1199-001.book Page 19 Thursday, April 8, 2010 1:35 PM

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 170 171

Comments to this Manuals

No comments