Bosch 0 607 595 100 Operations Instructions download pdf (Page 19)

English–8

2 609 929 157 • (04.08) T

Guide Plate with Rollers

The foam rubber cutter can be used with or without

the footplate 6. The footplate, furnished with rollers

16, allows the cutter to be guided in an easy and

straigt manner. Take care that there are no ob-

structions on the surface being cut.

In order to make freeform cuts and to make cutouts,

the footplate can be removed.

Removing the Footplate

Unscrew the clamping screw 15. Pull the footplate 6

from the saw blade guide 5.

Cutting

Work with a moderate rate of feed when you want to

make precise cuts, especially in the case of soft foams

and similar materials. Do not stretch and press the ma-

terial too strongly during cutting.

Note that too high a feed rate reduces the output ca-

pacity substantially and shortens the life of the saw

blades. Sharp tool bits provide good cutting power

and protect the tool.

When you want to make cutouts, remove the footplate

6 (see Removing the Footplate). Use a knife or a pair

of scissors to pierce a hole in the cutout to be made,

so that you can plunge in the saw blade guide. Make

the cutout with a moderate rate of feed.

Use only saw blades and saw blade guides that

are appropriate for the thickness of the material.

Only in this way can you achieve exact cuts.

Be sure to use the same length of saw blades

with the same matching saw blade guide. For ex-

ample, a saw blade set with a maximum cutting depth

capacity of 70 mm (2–3/4") can ONLY be installed in

a saw blade guide of 70 mm (2–3/4").

Changing the Saw Blades

When removing a saw blade, avoid contact with

skin and use proper protective gloves when

grasping the blade or accessory. Saw blades and

accessories may become hot during prolonged use.

Unscrew the two knurled nuts 8 nd remove them to-

gether with the lock washers and the faceplate 9.

Pull the saw blades 7 first out of the catch pins 13 be-

tween the drive blocks and then out of the saw blade

guide 5 at the guide pin 12.

Replace the saw blades with new, flawless saw blades

of the same size (see Installing the Saw Blades). If you

want to cut a different thickness of material, you also

have to change the saw blade guide.

Changing the Saw Blade Guide

Unscrew the slotted screws 10 from the housing 3.

Replace the saw blade guide 5 with a different one and

attach the new saw blade guide to the housing (see In-

stalling the Saw Blade Guide).

FoamC_bu_2609929157_t.fm Seite 8 Dienstag, 10. August 2004 12:36 12

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 133 134

Comments to this Manuals

No comments

Bosch 0 607 595 100 Operations Instructions Page 19

Comments to this Manuals