Bosch 0 607 595 100 Operations Instructions download pdf (Page 20)

English–9

2 609 929 157 • (04.08) T

Sharpening the Saw Blades

You can sharpen the saw blades yourself. Required

for this is the saw blade sharpener 24 and the whet-

stone 25 (see Accessories).

Always sharpen the saw blades in pairs. Unscrew the

screws on the sharpener 24, so that you can clamp

the saw blades in the holder 23. The beveled sides of

the teeth have to be oriented toward the top (un-

ground side of the saw blades toward the bottom, so

that the writing on the saw blades is readable). Firmly

screw the saw blades in the holder 23.

Pass the whetstone 25 evenly over the bevels of the

two saw blades. Several motions with the whetstone

suffice to give the saw blades sharp points once again.

The saw blades have to be thoroughly cleaned before

they are reinstalled.

6 MAINTENANCE AND SERVICE

Maintenance

Disconnect the air hose from the air supply be-

fore making any adjustments, changing acces-

sories, or storing the tool. Such preventive safety

measures reduce the risk of starting the tool acciden-

tally.

Should the tool fail in spite of careful manufacturing

and testing procedures, have the repairs performed by

an authorized customer service location for Bosch

power tools.

For inquiries and spare parts ordering, please include

the 10-digit order number on the nameplate of the

tool.

Clean the screen of the air inlet

regularly. For this purpose, un-

screw the hose nipple 1 and re-

move dust and dirt particles from

the screen. Then firmly remount

the hose nipple.

Water and dirt particles in the com-

pressed air cause rust formation and

lead to clogging of vanes, valves, etc.

To prevent this, a few drops of motor oil

should be placed in the air inlet 17. Re-

connect the tool to the air supply and

let the tool run for 5–10 s while catching the oil that

runs out with a rag. If the air tool is not used for a

longer time, this procedure should always be

performed.

All Bosch air tools that do not belong to the CLEAN se-

ries (a special kind of air motor that functions with oil-

free compressed air), require a small amount of lubri-

cating oil be mixed into the flow of compressed air.

The compressed air oiler required for this is located at

the compressed air maintenance unit connected to

the tool (you may obtain further details on this from a

compressor manufacturer).

You should use SAE 10 or SAE 20 motor oil for direct

lubrication of the tool or for admixture at the mainte-

nance unit (compressor).

Clean the saw blades 7 and the saw blade guide 5

every 8-10 hours of operation. Remove deposits in

the saw blade guide by using the scraper 26 included

in standard delivery.

The motor vanes should be routinely inspected by

trained personnel and, if necessary, replaced.

Have maintenance and repair work performed

only by qualified specialists. In this manner, it can

be ensured that the safety of the tool is maintained.

Any Bosch customer service center can perform this

work quickly and reliably.

Dispose of lubricants and cleaning agents in an

environment-friendly manner. Comply with the

legal regulations.

FoamC_bu_2609929157_t.fm Seite 9 Dienstag, 10. August 2004 12:36 12

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 133 134

Comments to this Manuals

No comments

Bosch 0 607 595 100 Operations Instructions Page 20

Comments to this Manuals