Bosch 3924-24 Operations Instructions download pdf (Page 34)

Adjustments

Disconnect battery pack from tool

before performing any assembly,

adjustments, changing accessories, or storing the tool.

Such preventive safety measures reduce the risk of starting

the tool accidentally.

NOTE: Your compound miter saw was completely adjusted

at the factory. However, during shipment, slight misalignment

may have occurred. Check the following settings and adjust

if necessary prior to using this compound miter saw.

Blade Square to Table (90°)

1. Rotate table 1 to 0° position and lock in place.

2. Lower the blade

2 and engage the lock pin 3. Use a

combination square

4 to check blade squareness to

table. Place the square on the table and press it against

the blade. If the blade does not contact the full length of

the square, (Figure 6) follow the alignment procedure.

90° Blade Alignment

a. Move sliding fence to proper position. (See Sliding

Fence on page 54.)

b. Loosen bevel lock handle

c. Loosen jam nut

6 using blade wrench supplied in

the handle, and lower 0° stop screw

7 with the

3 mm hex wrench provided.

d. Grasp carrying handle, move the head assembly

left or right until blade makes contact with the full

length of the square.

Tighten bevel lock handle

f. Adjust 0° stop screw

7 so that the hex screw head

hits the 0° stop at the same time the blade makes

contact with the full length of the square. Tighten

jam nut

6 (Figure 7).

FIG. 6

FIG. 7

WARNIN

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 91 92

No comments

Bosch 3924-24 Operations Instructions Page 34