@@2:/9F
AA.056;4 <<@2$.?A@
'
< .C<61 =<@@6/92 6;7B?F
16@0<;;20A =9B4 3?<: =<D2?
@<B?02 /23<?2 =2?3<?:6;4 .;F .@@2:/9F
.17B@A:2;A@<??2=.6?@
&A<?6;4A52::2E2F
There is a storage location on the saw to store the
5mm hex key. Insert the short leg of the hex key
through the rubber grommet as shown. Rotate long
leg under hook (see figure 1).
NOTE: The 5mm hex key is needed to change the
blade and to make tool adjustments.
AA.056;4XBE696.?F09.:=5<92
1. Position the 60˚ auxiliary clamp hole as shown in
figure 2.
2. Insert the screws provided into holes and tighten
with Philips screwdriver.
The 60˚ auxiliary clamp hole is used to appropriately
clamp material at angles from 55 ˚to 60˚ right see
page 25 for clamping instructions.
Comments to this Manuals