Bosch D1265 User's Guide download pdf (Page 22)

D1265 | User's Guide | Part II: System Commands

22 Bosch Security Systems, Inc. | 9/10 | F01U169131-02

7. When all points have been tested, 0 points

remain to be tested is shown.

Press the Exit button.

The display momentarily shows All points have

been tested.

The display then shows idle text.

Reset Sensors (CMD + 4 + 7)

Description

Detection devices, such as smoke detectors and shock

sensors, must be reset after being activated. This

function momentarily removes power from these

sensors to reset them.

Using Reset Sensors

1. Ensure the display shows disarmed idle text.

2. Press the CMD button. The display shows

*System Command*.

3. Press the 4 button, followed by the 7 button.

If you prefer, you might use the function

list in place of Steps 2 and 3 to initiate

this function.

Press the Menu button to enter the

function list.

Press the Next button repeatedly.

When you reach the Reset Sensors

button, press it.

4. The display shows for approximately 15 sec.

While the sensors reset, the keypad resets

before it returns to idle text.

If you enter this function and the detector or sensor

resets momentarily, but then returns to a faulted

condition, the conditions causing the activation might

still be present or the detector might be faulty. Check

to be certain that there is no smoke, fire, or other

danger present. If you can’t reset the detector or

sensor, contact your security company.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 35 36

No comments

Bosch D1265 User's Guide Page 22