Bosch PPR 250 User Manual download pdf (Page 18)

18 | English

2 609 005 736 | (16.1.12) Bosch Power Tools

Switching On (see figure D)

– Plug the mains plug into a socket outlet.

– Make sure that the pump lock 23 is engaged.

–To start the machine, push the On/Off switch 18 to the “I”

position.

– Grasp the paint applicator 3 or extension 1 by the respec-

tive handle and direct the paint roll 16 toward the surface

to be painted.

– Press the trigger switch 7 on the remote control 8.

Switching Off

– Release the trigger switch 7.

–To switch off the machine, push the On/Off switch 18 to

the “0” position.

– Pull the mains plug from the socket outlet.

– Disengage pump lock 23.

To relieve the lock tension, lightly push the pump lid 20 up-

ward, if required.

Working Advice

Painting

Before painting, moisten new or dried paint rolls with water.

When the paint roll is new or dry, it takes approx. six lanes un-

til the paint application is homogeneous and without streaks.

Filling an empty feed hose takes approx. one minute.

– Press the trigger switch 7 to apply a sufficient amount of

paint on the paint roll 16 and uniformly move the paint roll

up and down.

– Avoid interruptions within the surface to be painted.

Evenly guiding the paint roll will lead to a uniform surface

quality.

Regulating the Paint Amount during Painting

The paint amount can be regulated with the trigger switch.

– Press the trigger switch 7 until the application of paint on

the paint roll is homogeneous.

– Afterwards, release the trigger switch until the application

of paint on the painting surface is no longer opaque.

– Then, refill the paint chamber again with a sufficient

amount of paint (press trigger switch 7 approx. 5 sec-

onds).

Changing the Paint Roll (see figures E1 – E2)

Remove the paint roll from the paint applicator for cleaning or

when the paint roll is worn.

– Pull the roll holders 15 apart and allow the paint roll 16 to

slide out of the paint applicator 3.

To prevent the paint-soaked paint roll from drying out until it

has been washed out, it is best to immerse it into a water

bucket.

Appropriate new paint rolls can be found in our Bosch acces-

sories program.

Paint rolls from other manufacturers can also be used, when

the respective dimensions are observed (see “Technical Da-

ta”, page 16).

Insert a new paint roll as follows:

– Pull the roll axle 17 out of the old paint roll 16 and slide the

new paint roll on the roll axle until centred.

– Insert the roll axle 17 on one side in the roll holder 15 until

it fits.

– Press the paint roll into the roll holder of the other side.

The paint roll must be able to rotate freely.

Placing Down the Paint Applicator (see figure F)

– Place down the paint applicator 3 on the edge of the paint

bucket so that it rests on the bucket holder 14.

Correction of Malfunctions

Problem Cause Corrective Measure

Paint application unsatis-

factory.

The hoses are obstructed. No or too little

paint being transported.

Make sure that non of the hoses are squeezed or

creased.

The paint is too viscous and therefore cannot

be transported.

Stir paint thoroughly and dilute as required.

The pump lock 23 is not engaged. Make sure that pump lid 20 is properly inserted

and locked.

The paint bucket is empty. Refill the paint bucket with fresh paint or ex-

change the empty paint bucket against a full one.

No paint coming out of paint

applicator 3.

The paint is too viscous and cannot be drawn

in by the pump.

Stir paint thoroughly and dilute as required.

The hoses are obstructed. Clean the hose system (see “Cleaning”, page19).

The hoses are obstructed. No or too little

paint being transported.

Make sure that non of the hoses are squeezed or

creased.

The remote control 8 is

inoperative.

The base unit is switched off. Switch the base unit on (see “"Switching

On"Switching On”, page18).

The remote control battery is empty. Contact an authorised service agent for Bosch

power tools.

Have the component replaced there.

OBJ_BUCH-1513-003.book Page 18 Monday, January 16, 2012 11:29 AM

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 170 171

Bosch PPR 250 User Manual Page 18

Comments to this Manuals

Bosch PPR 250 User Manual Page 18

Comments to this Manuals

Related products and manuals for Power tools Bosch PPR 250