Bosch INTEGRUS Service Manual download pdf (Page 34)

34 en | Installation Integrus

IOM-INT | V1.1 | 2010.12 Installation and Operation manual Bosch Security Systems B.V.

Figure 5.9 Attaching the suspension bracket to the radiator

First assemble the supplied suspension bracket and connect it to the radiator (see Figure 5.8

and Figure 5.9). This bracket is attached to the radiator by two bolts with washers. There are

corresponding holes on the back of the radiators. There is also a spring-loaded plunger

(indicated by a black arrow in Figure 5.9), located above the bolt hole on the right-hand arm of

the bracket, which is used for adjusting the angle of the radiator (shown in inset in

Figure 5.9). There are corresponding holes on the back of the radiator for accepting this

plunger. The mounting angle can be adjusted in steps of 15°.

5.4.2 Mounting on a floor stand

Figure 5.10 Attaching the stud of a floor stand to the suspension bracket of the radiator

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 89 90

No comments

Bosch INTEGRUS Service Manual Page 34