Bosch MUM9AV5S00 Instruction Manual download pdf (Page 36)

36

en Re-adjustment of tools

Shortcrust pastry

Basic recipe

– 125 g butter (room temperature)

– 100-125 g sugar

– 1 egg

– 1 pinch salt

– A little lemon peel or vanilla sugar

– 250 g flour

– Baking powder if required

 Mix all ingredients with the professional

flexible beating whisk for about

½ minute at setting 1, then for about

2-3 minutes at setting 6.

From 500 g flour:

 Knead ingredients with

the kneading hook for

about ½ minute at setting 1, then

for about 3-4 minutes at setting 3.

Maximum quantity:

4 x basic recipe

Yeast dough

Basic recipe

– 500 g flour

– 1 egg

– 80 g fat (room temperature)

– 80 g sugar

– 200-250 ml lukewarm milk

– 25 g fresh yeast or 1 sachet dried yeast

– Peel from ½ lemon

– 1 pinch salt

 Mix all ingredients with the kneading

hook for approx. ½ minute at setting 1,

then for approx. 3-6 minutes at setting 3.

Maximum quantity: 3 x basic recipe

Note: For models with SensorControl Plus,

use the automatic programme. X “Using

SensorControl Plus” see page 32

Pasta dough

Basic recipe

– 500 g flour

– 250 g eggs (approx. 5)

– 2-3 tbsp (20–30 g) cold water

as required

 Mix all ingredients for about 3 to

5 minutes at setting 3 until a dough

forms.

Maximum quantity: 1.5 x basic recipe

Bread dough

Basic recipe

– 1000 g flour

– 3 sachets dried yeast

– 2 tsp salt

– 660 ml warm water

 Mix all ingredients with the kneading

hook for approx. ½ minute at setting 1,

then for approx. 4-5 minutes at setting 3.

Maximum quantity: 1,5 x basic recipe

Re-adjustment of tools

W Risk of injury!

Pull out the mains plug before re-adjusting.

Caution!

Only re-adjust tools in small steps. It must

be possible to completely lower the swivel

arm, and when doing so, the tools should

not catch on the bottom or on the edge of

the bowl. The optimum distance between

the tools and the bowl is 3 mm.

X Image sequence O

 Insert the professional stirring whisk and

check the current setting.

 Press the release button and raise

the swivel arm to the stop.

 Hold the tool with one hand. Release

the lock nut in a clockwise direction

using a spanner wrench (10 mm).

 Adjust the distance to the bowl by

turning the tool (1 whole turn corre-

sponds to a height adjustment of 1 mm).

Turn anticlockwise:

Distance to bowl is reduced.

Turn clockwise:

Distance to bowl is increased.

 Press the release button and push the

swivel arm down until it locks into place.

 Check the tool distance. The optimum

distance between the tools and the bowl

is 3 mm. Adjust if necessary.

 Once the distance is perfectly adjusted,

press the release button and move the

swivel arm back.

 Hold the tool with one hand. Turn the

lock nut in an anticlockwise direction

using a spanner wrench (10 mm).

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 187 188

Comments to this Manuals

No comments