Bosch D9112B User's Guide download pdf (Page 35)

WALK TEST ?

Walk Test

Description

Use this function to test command centers, detection devices,

and sounders (both interior and exterior) to be certain they

function properly. You can review untested points at your

command center to help pin-point any problems.

You cannot arm your system while in the walk test mode, and no

alarm reports are sent to your security company unless a 24-

hour point is activated (such as fire or panic).

Upon initiation, the walk test will test the burglary bell pattern

on the bell output and ring the command center burglary bell

for 2 seconds. The AC will be disabled for 4 minutes in order to

test the system’s battery power. If the battery cannot maintain

the system for the 4 minute period, the command center will

appear to go dead. If this happens, contact your security company.

At the end of the 4 minute period, AC is returned to the system

and the panel restores. To test individual detection devices, simply

activate sensors and open protected doors and windows one-at-

a-time. As each detection device is faulted, the Command Center

emits a brief tone and the display indicates for 60 seconds that

the point has been tested. This verifies that each detection device

is working properly.

Using Walk Test:

1. Ensure your command center shows idle disarmed text.

2. Press the COMMAND bar. The display shows SYSTEM

COMMAND.

3. Press the 4 key, followed by the 4 key.

Note: If you prefer, you may use the Command Menu in place

of steps 2 and 3 to initiate this function. Press the MENU

key to enter the Command Menu, then press NEXT

repeatedly until you reach the WALK TEST ? prompt.

Press ENT.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 55 56

No comments

Bosch D9112B User's Guide Page 35