Bosch GREENSTAR HEATSLAVE II EXTERNAL 12/18 Service Manual download pdf (Page 9)

Operation

The Greenstar Heatslave II is supplied as standard suitable

for sealed primary water systems. The appliance contains

an expansion vessel, 3bar pressure relief valve, pressure

gauge and an automatic air vent.

Oil

These appliances are for use on 28 sec kerosene fuel only.

Hot water mode

With the appliance in a standby condition, i.e. the heatbank

at a temperature set by the hot water thermostat, when a

demand for hot water is required the flow switch will

energise the pump and circulate primary hot water around

the boiler and the plated water to water heat exchanger.

The burner will automatically light to maintain the

temperature of the heatbank.

When hot water is no longer required, the appliance will

continue to operate until the heatbank has returned to

temperature. Priority is always given to the production of

domestic hot water.

There are two hot water modes on the appliance. In the

standard mode the burner fires soonest to keep the thermal

store temperature high, maximising hot water comfort. In

ECO mode the thermal store temperature is allowed to fall

more before the burner fires, saving fuel.

Central heating mode

When central heating is required, the diverter valve will

open and the pump will energise in order to circulate

primary water around the heating system. The burner will

automatically light and the radiators will heat up to the

temperature set by the heating control thermostat.

Greenstar Heatslave II External model

Installation of a

Greenstar Oilfit

RS flue system

Applications

•

The outputs offered by the range ensures installation

ﬂ exibility, making Greenstar oil-ﬁ red boilers ideally suited

to many sizes of domestic property

•

The Greenstar Heatslave II will accept pre-heated DHW

to 60ºC from sources such as solar and biomass. They

are ideally matched to our range of Greenskies solar

thermal panels.

Fluing

The indoor appliance can be used with

either a room sealed concentric flue or

conventional (open) flue. A flexi-flue liner kit is available to

enable the appliance to be flued via a chimney. The room

sealed flue ensures quiet operation.

The external appliances utilise a balanced flue system in

order to minimise the risk of lockouts caused by heavy winds.

A standard flue kit is included with every external boiler.

A plume management kit is available for both internal and

external boilers.

Greenstar Oilfit – the easy-fit fluing solution

•

Multiple fluing options with the ability to flue internal floor

standing boilers from the top, rear or side and external

boilers from the rear and side

•

Conventional flue via the adaptor kit or flexi-flue chimney

liner kit

•

Room sealed flue lengths using 80/125mm dia. flue up to

8m vertically and 6m horizontally. Plume kit lengths to 5m

•

Quick-to-install push-fit connections and telescopic options

which form a gas-tight seal and in most cases eliminate the

need to cut the flue

•

Easy-fit installation that requires no special tools when

fitting flue extensions, elbows and adaptors.

Greenskies Solar-Lux,

Solar-Lifestyle and

Solar-Lito

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 55 56

Comments to this Manuals

No comments

Bosch GREENSTAR HEATSLAVE II EXTERNAL 12/18 Service Manual Page 9

Comments to this Manuals

Related products and manuals for Water heaters & boilers Bosch GREENSTAR HEATSLAVE II EXTERNAL 12/18