Bosch CM8S Use and Care Manual download pdf (Page 20)



'< .C<61 =<@@6/92 6;7B?F

6@0<;;20A =9B4 3?<: =<D2?

@<B?02 /23<?2 =2?3<?:6;4 .;F .@@2:/9F

.17B@A:2;A<??2=.6?

52086;4 23AO2C2917B@A:2;A

. Lower head assembly and engage head assembly

lock pin.

2. Rotate table to 0° miter position and lock.

3. Slide the head assembly completely to the back

and engage the slide rail lock knob by tightening

the knob to the right (clockwise).

4. Slide the fence completely to the left to avoid hitting

it with the saw head.

5. Pull bevel lock lever forward to unlock the head

assembly.

6. Check range of bevel range selector stop. It should

be at 45°, (figure 18).

7. Tilt the saw assembly to the left until you feel it

stop. This is where the saw is currently set for 45°

bevel cut.

8. Use a combination square to check blade

squareness to the table. Place the combination

square on the table and press its 45° surface

against the blade. If the blade does not contact the

full length of the square, follow the calibration

procedure. (see figure 19)

.96/?.A6;49.12.A 23AO2C29

Note: Use a 3/8” (10mm) wrench for adjustment.

Note: Calibrating the bevel setting automatically

calibrates the 33.9°, 22.5°, and 45° left stop.

1. Lower head assembly and engage head assembly

lock pin.

2. Slide the head assembly completely to the back

and engage the slide rail lock knob by tightening

the knob to the right (clockwise).

3. Slide the fence completely to the left to avoid hitting

it with the saw head.

4. Check bevel range selector stop located on the

left side of the bevel post on the table. It should be

at 45°.

5. Pull the bevel lock lever forward to unlock the head

assembly.

6. Locate the bevel stop bolt along the left side of the

bevel post. This bolt features a lock nut. (figure 18)

7. Loosen the bevel stop bolt a quarter turn and then

loosen the lock nut. When this is complete you will

be able to adjust the bevel stop bolt by hand.

A. Rotate the bevel stop bolt clockwise to adjust

the head to the lift.

B. Rotate the bevel stop bolt counter-clockwise

to adjust the head to the right.

8. Follow the procedure in “Checking Left 45° Bevel

Adjustment” to check your modifications. If further

adjustment is required, repeat the steps above.

9. Once satisfactory, lock the bevel lock lever at 45°

to prevent movement.

10. Finger tighten the lock nut in place. Once

secured, tighten with wrench.

17B@A:2;A@

O2C29&A<=

FIG. 19

FIG. 18

2C29

&A<=<9A

<08"BA

2C29%.;42

&2920A<?&A<=

*%""

BM 2610025580 05-13_BM CM8S 5/17/13 1:37 PM Page 20

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 131 132

Comments to this Manuals

No comments

Bosch CM8S Use and Care Manual Page 20

Comments to this Manuals

Related products and manuals for Mitre saws Bosch CM8S