Bosch D9210C Specifications Page 29

  • Download
  • Add to my manuals
  • Print
  • Page
    / 32
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 28
Access Control Interface Module | en 29
Bosch Security Systems, Inc. Installation and Operation Guide F.01U.215.244 | 05 | 2012.06
A Appendices
A.1 D9210C Terminal Quick Reference and Electrical Specifications
# Terminal Description Electrical Specifications
1 PWR 12 VDC power input 8.5 - 13.8V [depending on reader
draw: 110 mA (board) + 150 mA
(reader max) = 260 mA]
2 A Data from the control panel
to the D9210C
High impedance bi-directional
differential bus
3 B Data back to the control panel
from the D9210C
RS-485 @ 9600 baud
4 COM Common for connection to
SDI COM on control panel and
common on power supply
5 NC Continuity with LCK COM
when relay is off
12/24 V @ 2.0 A max (30 VDC max)
6 C Input to feed LCK N/C (T2)
and Lock N/O (T3)
7 NO Continuity with LCK COM
when relay is on.
12/24 V @ 2.0 A max (30 VDC max)
8 T+ Positive input for Tamper,
normally open
Input 1 kΩ pull upV in < 1.8 V on >
3.2 V off
9 COM Common for on-board
point and tamper inputs
1K Ω termination resistor between
T9 and T10 required
10 ZN+ Positive Input for on-board
point (zone)
11 RTE Input from Request to Enter
(RTE) momentary short device
Input 1kΩ pull upV in < 1.8 V on >
3.2 V off
12 COM Common input for REX/RTE
devices
13 REX Input from Request to Exit
(REX) momentary short device
Input 1 kΩ pull upV in < 1.8 V on >
3.2 V off
14 12 VDC Power for 12V reader 8.5-13.8V
15 +5.2VDC Power out to 5.2 VDC
card reader
V out 5 V+/_ .25 V for 20 - 140 mA
load150 mA maximum continuous
16 DATA 0 Data 0 input from card
reader
High impedance inputs with 47kΩ
pull up to +5.2 VDC
17 DATA 1 Data 1 input from card
reader
High impedance inputs with 47kΩ
pull up to +5.2 VDC
18 BUZZER Buzzer common upon strike
activation
Sink up to 35 mA from 5 - 14 VDC
sourceOutput impedance is 100 Ω
19 LED LED common upon card read
response and strike activation
Sink up to 35 mA from 5 - 14 VDC
sourceOutput impedance is 180Ω
Page view 28
1 2 ... 24 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments