Bosch CTL636EB1 Instruction Manual download pdf (Page 38)

34

en Initial use

C start/stop

Press C for either beverage preparation

or to launch a service programme.

Press C again while the drink is being

prepared to prematurely halt dispensing.

There are four menu elds in the control

panel which can be activated by touching.

The active menu eld lights up red.

m

m lights up as soon as the

appliance is in operation. Drinks can be

selected and dispensed or settings for the

drinks can be changed.

B MyCoffee

Touch B to open the selection of

“ Personalised beverage preparation”.

Personal settings for coffee drinks can

be saved and called up (see the section

“ Personalised drinks”).

A Menu

Touch A to call up the menu. Settings

can be made and information called up

(see the section “Menu”).

E Service

Touch E to open the selection of service

programmes. Run the desired programme

as described in the section “Service

programmes”.

F

Press A, E or B again to exit

the respective menu.

Control ring

Turn the control ring to navigate in the

display or to change parameters.

Information display

The round display shows the drink selected,

the settings or information.

Touch display (left and right)

Depending on the setting, different elds

are shon in both the touch displays. A eld

is activated when touched either to enter

settings or change values.

Initial use

General

Fill the appropriate container using only

pure, cold, uncarbonated water and solely

roasted beans. Do not use coffee beans

that have been glazed, caramelised or

treated with other additives containing

sugar, since they will block the brewing unit.

A

Before the appliance can be switched

on and used, it must be assembled

and connected according to the

enclosed assembly instructions.

Setting up the appliance

■ Remove any protective plastic lm.

F

Important: Only use the appliance

in a frost-free room. If it has been

transported or stored at tempera-

tures below 0°C, wait at least 3 hours

before initial use.

■ Take hold of the appliance door by the

recessed grip and open.

■ Remove the water tank, rinse it and ll it

with fresh water up to the “max.” mark.

■ Replace the water tank and click into

place.

■ Remove the bean container, ll with

coffee beans and replace.

■ Set the mains switch to I and close

the appliance door.

The appliance heats up and is rinsed.

The control panel is activated.

“Language” appears.

■ Turn the control ring with your nger to

select the desired language and touch the

[ Water hardness ] eld.

F

It is important to set the water hard-

ness correctly to enable the appli-

ance to accurately indicate when the

descaling programme should be run.

The preset water hardness is level 4.

If a water softener is installed in the

house, please set the water hard-

ness to level 3. You can also check

the water hardness by asking your

local water supplier.

1 ... 37 38 39 ... 120

Comments to this Manuals

No comments