Bosch 4410L Operations Instructions download pdf (Page 14)

Adjustments (continued)

Disconnect plug from power source

before performing any assembly,

adjustment or repair to avoid possible injury.

Checking Right 45°

Bevel Stop

1. Lower head assembly and engage head assembly

lock pin.

2. Slide head assembly completely to the back and

tighten the rail lock knob.

3. Rotate table to the 0° miter position.

4. Pull up bevel lock lever to unlock bevel.

5. Move bevel range selector knob to "0o-45° Right"

position. (See page 28)

6. Tilt the saw to the right until you feel the stop in the

45° right position. This is where the saw is cur-

rently set for the 45° right bevel cut.

7. Use a combination square to check blade at the

45° stop. Place the combination square head on

the table and press it's 45° surface against the

blade. If the blade does not contact the full length

of the square, (figure 1), follow the calibrating pro-

cedure.

Calibrating Right 45°

Bevel Stop

1. Lift bevel lock lever to release bevel lock.

2. Tilt saw to 45° right bevel position.

3. Position combination square with 45° surface

against blade. (Figure 1)

4. Insert 3 mm '%"wrench into hole in vertical support

frame. (Figure 2)

5. Rotate '%" wrench while viewing blade against

combination square until it matches 45° surface.

6. Adjust bevel pointer to 45° line on bevel scale.

3mm

Wrench

Figure 1. Right 45° Bevel Stop

Adjusting

Access Hole

Figure 2. Right 45° Bevel Adjustment

14.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 115 116

No comments

Bosch 4410L Operations Instructions Page 14