Bosch 4410L Operations Instructions download pdf (Page 19)

Transporting, Placement & Mounting

To avoid injury always observe the

following:

• Unplug electric cord. Before transporting the saw,

rotate head and lock assembly to 60 ° right miter,

lock into detent, slide head assembly to the middle

of it's rail, tighten the slide rail lock knob and lock

the head assembly in the lowered position.

Lifting Saw

• To avoid back injury, hold the tool close to your

body when lifting. Bend your knees so you can lift

with your legs, not your back.

• Lift by using the cast-in carry handles at each

side of the bottom of the base.

• Alternate lifting method: When picking tool up

from ground, use rear carrying handle and front

carrying handle (above guard).

• Never carry the tool by the slide rails, this

may cause blade damage.

• Never lift tool by holding main switch handle.

This may cause serious damage.

• Never carry the miter saw by the power cord or the

operational handle. Attempting to lift or carry the

tool by the power cord will damage the insulation

and the wire connections resulting in electric shock

or fire.

• Observe the position of the saw. People standing

behind it could be injured by thrown debris.

• Place the saw on a firm, level surface where there

is plenty of room for handling and properly support-

ing the workpiece.

• Bolt, nail or clamp the saw to its support.

Be careful not to over-drive nail

or over-torque the bolt. This could

crack foot or damage base.

Mounting Applications

Mounting to Workbench

Mount the saw using either the four bolt holes (5/16")

or the four nail holes to the workbench. Check for

clearance to the left and right of the saw.

1. Each of the four mounting holes should be bolted

securely using 5/16" bolts, lock washers, and hex

nuts (not included).

2. Locate and mark where the saw is to be mounted.

3. Drill four (4) 5/16" diameter holes through work-

bench.

4. Place the miter saw on the workbench aligning

holes in base with holes drilled in workbench.

Install bolts, lock washers and hex nuts. As an

alternative, you can mount the saw using drywall

screws in the four nail holes.

Supporting surface where saw is to be mounted

should be examined carefully after mounting to

ensure that no movement can occur during use. If

any tipping or walking is noted, secure the work-

bench or stand before operating the slide com-

pound miter saw.

Rear Carrying

Handle

Front Carrying

Handle

Bolt Hole

Nail Hole

Figure: Workbench Mounting

19.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 115 116

Comments to this Manuals

No comments

Bosch 4410L Operations Instructions Page 19

Comments to this Manuals

Related products and manuals for Mitre saws Bosch 4410L