Bosch 4410L Operations Instructions download pdf (Page 16)

Adjustments (continued)

Disconnect plug from power source

before performing any assembly,

adjustment or repair to avoid possible injury.

Blade Square to Fence

1. Slide saw forward so blade is near the center of

the table and tighten slide rail lock knob.

2. Lower head assembly and engage head assem-

bly lock pin.

3. Set table at the 0° miter position and tighten miter

lock knob.

4. Place combination square against fence with ruler

of square parallel to blade. Ruler should contact

blade, but not blade teeth. If blade is not square

against ruler, follow the fence alignment proce-

dure. (Figure 1)

5. Loosen rail lock knob and slide head assembly

back to check squareness of complete slide cut

against the square's ruler.

Fence Alignment

a. Remove both fences by loosen fence knob, slide

fence to full in position, and pull up on fence.

b. The head assembly should remain in lowered

position.

c. Loosen the four (4) hex bolts behind fence using

multi purpose wrench (Figure 2).

d. Adjust fence until blade and fence have full con-

tact with the square.

e. Tighten the four (4) hex bolts.

f. Re-attach sliding fence.

Combination Square

Figure 1. Blade Square to Fence

Fence Hex

Knob Bolts

Hex Fence

Bolts Knob

Figure 2. Fence Adjustment

Miter Scale

Indicator Adjustment

1. Set table at the 0° miter position and tighten miter

lock knob.

2. Raise the head assembly to the full-up position.

3. Loosen the Phillips screw that holds the indicator

in place.

4. Position the indicator to align with the 0° miter

mark and tighten the screw.

Indicator

Adjustment

Screw

16.

0° Mark

Miter Scale

Indicator

Figure: Miter Scale Adjustment

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 115 116

Comments to this Manuals

No comments

Bosch 4410L Operations Instructions Page 16

Comments to this Manuals

Related products and manuals for Mitre saws Bosch 4410L