Bosch CM10GD Use and Care Manual download pdf (Page 20)



17B@A:2;A@

!6A2?2A2;A&F@A2:J17B@A:2;A$?<021B?2

.96/?.A6;4!6A2?2A2;A&F@A2:

1. Engage the miter detent at the 0° position. Loosen

the miter lock knob 1/2 turn.

2. Look for four round holes in the miter scale plate.

In each hole is a screw. Use the small end of the

6/4mm hex key or a 4mm hex key to loosen all

four screws 1 to 2 turns. This will loosen the miter

detent plate (see Figure 18).

64B?2

3. Lock saw down using the head assembly lock pin

(item 43 – page 9).

4. Hold one side of a 90° combination square against

the fence and rotate the table (and detent plate)

until the side of the saw blade is in full contact with

the other side of the square.

64B?2

5. Tighten all four screws – loosen and reset the

miter scale pointer to the “0” position.

!6A2?&0.92$<6;A2?17B@A:2;A

1. Rotate table to 0° position and lock in place.

2. Raise the head assembly to the full UP position.

3. Loosen the pointer adjust screw that holds the

miter scale pointer in place (see Figure 20).

4. Position the pointer to align with the 0° line.

Tighten the screw.

64B?2!6A2?&0.9217B@A:2;A

2?3;@2?A17B@A:2;A

The kerf inserts should be adjusted close to the

blade, but without touching the blade, to avoid tear-

out on the bottom of the workpiece.

1. Hold the saw head assembly down and push in

the head assembly lock pin (item 43 – page 9) to

keep the saw in the DOWN position.

2. Loosen the six kerf screws using small end of 6/4

mm hex key or 4 mm hex key.

3. Adjust the kerf inserts as close to the blade (teeth)

as possible without touching the blade.

4. Tighten the kerf screws.

NOTE: At extreme bevel angles, the saw blade may

slightly cut into kerf insert.

64B?22?3;@2?A@

Detent Plate

Screws

Contacting

Fence

Contacting

Blade

Combination

Square

Set Miter

Detent at 0°

Pointer Adjust Screw

Miter Scale Pointer

0° Line

Kerf Inserts

Kerf Screws

BM 2610027879 07-13_BM 2610027879 07-13.qxp 7/8/13 9:52 AM Page 20

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 163 164

Comments to this Manuals

No comments

Bosch CM10GD Use and Care Manual Page 20

Comments to this Manuals

Related products and manuals for Mitre saws Bosch CM10GD