Bosch CM10GD Use and Care Manual download pdf (Page 46)



The preferred method for cutting crown molding with

this saw is with the molding lying flat on the table.

The advantage to cutting molding angled against

fence is that no bevel setting is required. Only the

miter angle is adjusted.

The maximum crown molding width that can be cut

and angled to table and fence is 5-1/2".

When cutting crown molding in this fashion it is

recommended to purchase and use the optional

Crown Stop Set (see page 55).

<99<DA52@26;@A?B0A6<;@3<?0BAA6;4

0?<D;:<916;4.;4921A<A./92.;132;02

1. Position the molding so the bottom (decorative

part, which is installed against the wall) is against

the fence.

2. For 90° corner, set the miter angle using chart

below. Tighten the miter lock knob.

3. Support crown molding against the fence (see

“Body and Hand Position” on page 28.)

4. Follow the procedures for chop or slide cut (see

pages 34-35).

5. Wait until blade comes to a complete stop before

returning head assembly to the raised position

and/or removing workpiece.

NOTE: Always take a test cut using scrap to confirm

correct angles.

64B?2?<D;!<916;4;4921A<

'./92.;12;02

45° Miter

Optional

Crown Stop

Crown Molding

Angled Against

Fence

Bottom

Edge of

Molding

&.D#=2?.A6<;@

?<D;!<916;4;4921A<'./92.;12;02

!6A2?.;12C29&2AA6;4@3<?&A.;1.?1?<D;!<916;4BA@

*52;*<?8=6202;49214.6;@A2;02

@@B:=A6<;@ Molding is milled consistently.

Corner is 90°.

For other corner angles, divide actual measurement

by 2.

%232?A<5.?A

BAA6;4J;4921A<'./92.;12;02

Ceiling

45° Spring Angle

38° Spring Angle

52° 45°

38°

45°

Wall

Ceiling

Wall

45/45° Crown Molding

38/52° Crown Molding

Inside

Corner

Outside

Corner

Fence

Table

Molding Placed

Upside Down

Bottom Edge

Crown Stop

BM 2610027879 07-13_BM 2610027879 07-13.qxp 7/8/13 9:52 AM Page 46

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 163 164

Comments to this Manuals

No comments

Bosch CM10GD Use and Care Manual Page 46

Comments to this Manuals

Related products and manuals for Mitre saws Bosch CM10GD