Bosch CM10GD Use and Care Manual download pdf (Page 41)



&.D#=2?.A6<;@

2C29BA@

(@6;4A522C29%.;42&2920A<?;</

2C29%.;42H 23A

This left-side bevel range is the default setting.

'<<=2?.A26;2C29%.;42

1. Move the left sliding fence out to clear saw

assembly and relock (Figure 51).

2. Lift bevel lock lever above table height with left hand.

3. Grasp the main handle with the right hand and tilt

the saw assembly to the angle desired.

4. Once in the desired bevel position, hold the saw

assembly with right hand and use left hand to fully

press down the bevel lock lever below table height.

NOTE: Without turning the saw “ON,” perform a dry

cut to make sure the fence clears the guards and

adjust if necessary.

2C29%.;42H%645A

'<<=2?.A26;2C29%.;42

1. Move the right sliding fence out to clear saw

assembly and relock (see Figure 51).

2. Lift bevel lock lever above table height with the left

hand.

3. Grasp the main handle with the left hand and tilt

the saw assembly slightly to the left while rotating

the spring-loaded bevel range selector knob with

the right hand so the knob’s indicator points to “0-

45° Right” as on the label.

4. Once in the desired bevel position, hold the saw

assembly with right hand and use left hand to fully

press down the bevel lock lever below table height.

NOTE: When the saw assembly is tilted back to left

past 0°, the bevel control knob will snap back to the

default bevel range 1. This is designed to regain the

preset bevel stop at the important 0° position.

2C29%.;42!.E2C29;492A<H 23A<?

%645A

This full-capacity bevel range setting overrides all

preset stops and allows for cutting at bevel angles

beyond the normal 45° on either side.

'<<=2?.A26;2C29%.;42

1. Move the left and right sliding fences out to clear

saw assembly and relock (see Figure 51).

2. Lift bevel lock lever above table height with the left

hand.

3. Grasp the main handle with the left hand and tilt the

saw assembly slightly to the left while rotating the

spring-loaded bevel range selector knob with the

right hand so the knob’s indicator points to the red

square below “Max. Bevel Angle to 47° Left or Right.”

4. Once in needed bevel position, hold saw head by

the right hand and use left hand to press down the

bevel lock lever below table height.

NOTE: The selector knob will stay in this “override”

position. Turn the knob slightly clockwise and it will

snap back to bevel range 1 (default position).

64B?2

64B?2

BM 2610027879 07-13_BM 2610027879 07-13.qxp 7/8/13 9:52 AM Page 41

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 163 164

Comments to this Manuals

No comments

Bosch CM10GD Use and Care Manual Page 41

Comments to this Manuals

Related products and manuals for Mitre saws Bosch CM10GD