Bosch CM10GD Use and Care Manual download pdf (Page 49)



64B?2

10-19/32"

3-1/16"

7-15/32"

OVERALL LENGTH = 26-1/16"

3-1/16"

OVERALL HEIGHT = 1-1/2"

Drill 4 Holes = 5/16" Diameter

5/16"

New Auxiliary Fence

(assembled to Miter Saw)

Stationary

Fence

Saw Base

Top of Base

and Table

Note: The Stationary Fence is permanently

attached to the Saw Base (do not remove)

Stationary

Fence

5/16" Hole Through

1/2" Countersink

1/4" Flat Head Machine Screw x 2-1/2" Long

(need 4)

Flat Washer (need 4)

Nut (need 4)

Top of Base

and Table

Saw Base

New Auxiliary Fence

Board: 3/4" Wide x 1-1/2" High

Auxiliary Fence - Using an Auxiliary Fence when cutting Crown molding flat on the table will reduce splintering of your workpiece

and movement of small cut-off pieces. Remove the saw’s sliding fences (see page 29) before attaching the auxiliary fence.

Build auxiliary fence by following pattern below - Material: 3/4" x 1-1/2" wood.

Add 4 holes as dimensioned on pattern -or- Add holes following the next steps:

1) Cut wood to the outside dimensions shown and temporarily attach to saw’s stationary fence using two C-clamps.

2) Use 1/4" drill bit to drill first through existing holes in the rear of the stationary fence and then through the wood.

3) Remove wood, countersink the front of the wood and permanently attach to saw’s fence with hardware shown below.

&.D#=2?.A6<;@

?<D;!<916;4BE696.?F2;02

BM 2610027879 07-13_BM 2610027879 07-13.qxp 7/8/13 9:52 AM Page 49

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 163 164

No comments

Bosch CM10GD Use and Care Manual Page 49