Bosch D6100IPv6 Installation Guide download pdf (Page 19)

Conettix D6600/D6100IPv6 | Program Entry Guide | 2.0 CPU Configuration

Bosch Security Systems, Inc. | 11/12 | 4998122702-07

2.4.12 SIA Fire Restore

Default: 0

Selections: 0 or 1

0 The automation PC sends a common Fire

Restoral code if programmed for SIA Output

Mode.

1 The automation PC differentiates between

Fire Restoral after Alarm and Fire Restoral

after Trouble, Missing, or Supervisory if

programmed for SIA Output Mode.

All Bosch control panels using the Modem IIe and

IIIa

formats differentiate between Fire Restoral after

Alarm and Fire Restoral after Trouble, Missing, or

Supervisory in the message that is sent to the

D6600/D6100. SIA Automation Output Mode can also

differentiate between these two message types, or it

can combine them into a common Fire Restoral

message.

If the Modem IIe Fire prompt is

programmed “0,” the programming of

the SIA Fire Restore prompt has no

effect on the SIA Automation Output

Format.

Table 4: SIA Fire Restore Examples

SIA

Mode

SIA Fire Restore = 0 SIA Fire Restore = 1

FIRE ALM

RESTOR

<header>[#aaaa|NriaF

Rppp]

<header>[#aaaa|NriaF

Hppp]

FIRE TBL

RESTOR

<header>[#aaaa|NriaF

Rppp]

<header>[#aaaa|NriaF

Jppp]

2.4.13 Packet Separator (/)

Default: 0

Selections: 0 or 1

0 Final packet separator is not sent in SIA

automation message.

1 Final packet separator is sent in SIA

automation message.

This prompt enables the final packet separator (/) (in

SIA Output Mode) when messages with event

modifiers are sent to the automation PC.

2.4.14 Sub Subscriber

Default: 0

Selections: 0 or 1

0 Sub subscriber (sub user) data is not sent

to SIA automation output.

1 Sub subscriber (sub user) data is sent to

SIA automation output.

This is a programmable modem format only item that

determines whether the specific access control card

or token number identifier (sub user) is also sent to

the SIA automation output.

2.4.15 Output Format

Default: 1

Selections: 0 to 2

0 COM3 port disabled

1 6500 format (expanded reporting)

2 SIA Computer Interface Standard format

If you disable the COM3 port by

selecting 0 after selecting an automation

output format, you must reboot the

receiver.

Set Menu Item 6.3.7 Device to 2 to use COM3

RS-232 and the output format programmed in

2.5.15 Output Format.

Set Menu Item 6.3.7 Device to 1 to use the output

format programmed in Menu Item 6.3.6 Network

Automation Output Format on page 43.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 48 49

Comments to this Manuals

No comments

Bosch D6100IPv6 Installation Guide Page 19

Comments to this Manuals

Related products and manuals for Car media receivers Bosch D6100IPv6