Bosch D6100IPv6 Specifications download pdf (Page 65)

Initial IP Address Assignment Using ARP.EXE

The D6100i you are configuring and the computer used to configure it must both be on the

same gateway (the device that connects the LAN to the WAN) to use telnet for configuration of

the D6100i. The gateway can be a router or a hub. After you configure the D6100i and assign it

an IP address, you can then use telnet to change configuration parameters from anywhere on

the network.

Notice!

Read this entire procedure before starting. Ensure that power is applied to the D6100i and

then connected to the LAN or WAN through the Ethernet connector.

The following procedure shows how to use the ARP command to assign an IP address to the

D6100i.

Notice!

The IP and MAC addresses in this procedure are examples and are not the same as those for

your D6100i.

1. Select Start → Run.

The Run dialog box appears.

2. In the Run dialog box, type COMMAND and click OK.

A DOS window appears.

3. At the DOS command line, type:

arp -s xxx.xxx.xxx.xxx zz-zz-zz-zz-zz-zz

and press Enter.

Notice!

xxx.xxx.xxx.xxx is the IP address the network administrator assigned to the D6100i

zz-zz-zz-zz-zz-zz is the MAC address printed on the back of the D6100i

For example:

The program responds with a prompt to indicate that the address was accepted.

1. Verify that you entered the IP address correctly. Type:

arp -g

and press Enter.

This command displays the IP address 172.17.10.70 temporarily linked to MAC address

00-20-4a-12-04-0e as shown. The temporary link shows a static entry.

12.5.3

Conettix Communications Receiver/

Gateway

Network Communications | en 65

Bosch Security Systems, Inc. Installation and Operation Guide 2012.11 | 08 | 4998122704

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 87 88

No comments

Bosch D6100IPv6 Specifications Page 65