Bosch CM10GD Use and Care Manual download pdf (Page 53)



$%# !

Brake does not stop blade in about

5 seconds.

Motor does not start.

Flash of light from motor endcap

when switch is released.

(&

1. Brushes not seated or lightly

sticking or worn.

2. Motor overheated from use

of dull blade/too heavy of a

blade, not recommended

accessory or rapid on/off

cycling.

3. Blade bolt loose.

4. Other.

1. Check that unit is plugged in.

2. Power source fuse or

time delay fuse.

3. Brushes worn.

4. Other.

Normal - brake working properly.

#%%')'#"

- Inspect/clean or replace

brushes (see Maintenance

and Lubrication section).

- Use sharp blade.

- Use a recommended blade.

- Let saw cool down.

- Tighten blade bolt.

- Authorized service.

- Plug unit in. Use different

outlet.

- 15-Amp time delay fuse or

circuit breaker.

- See Motor Brush Replacement in

the Maintenance and Lubrication

section.

- Authorized service.

–

'?<B/92@5<<A6;4

'?<B/92@5<<A6;4B612920A?60.9

BM 2610027879 07-13_BM 2610027879 07-13.qxp 7/8/13 9:52 AM Page 53

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 163 164

Comments to this Manuals

No comments

Bosch CM10GD Use and Care Manual Page 53

Comments to this Manuals

Related products and manuals for Mitre saws Bosch CM10GD