Bosch DS7400XiV4-EXP User Manual download pdf (Page 13)

DS7400XiV4-EXP | User Guide | 6.0 Day to Day Operations EN | 13

Bosch Security Systems | 6/05 | 4998154961B

6.2 Optional Operations

6.2.1 Quick Arming

Quick arming allows you to enter some arming commands without first entering a PIN. If quick arming is not

used, you must enter a PIN at the beginning of all arming command sequences.

Quick arming is not available from a Master keypad or from RF (wireless) keypads.

The following shortcuts are allowed when the system is programmed for quick arming:

Table 9: Quick Arming

Type of Arming Quick Arming Command Sequence

Normal Arming [#][On]

Perimeter Instant Arming – no entry delay [#][No Entry][Perimeter Only]

Perimeter Arming – entry/exit delay in effect [#][Perimeter Only]

Maximum Security Arming [#][No Entry][On]

6.2.2 Force Arming

When one or more zones are faulted (for example, if a window or door is open), the system can be force armed (if

programmed) by bypassing the faulted zones. When a text keypad displays “Not Ready” and the zone LED(s) on

an LED keypad for the faulted zone(s) are lit, force arming is required to arm the system. Although an RF3341

keypad does not indicate a faulted state on the system, you can force arm the system from an RF3341 keypad.

You can also force arm an area using a master keypad in Single Partition Mode.

Force Arming during an AC power failure: Regular arming of the control panel is not permitted during an

AC power failure. The requirement to force arm serves as a warning that the control panel is operating under

backup battery.

Bypassing or force arming removes some of your building’s protection because it excludes the faulted

zones from arming. Therefore, an intrusion might not be detected or the detection might be delayed.

Always attempt to correct any zone problems (close doors and windows, etc.) before using these

features. If you cannot correct the problem, contact your installing company.

Table 10: Force Arming

Equipment Command Sequence What Happens What To Do

Text Keypad LED

Keypad

Enter any Arming

Command Sequence.

Enter [Bypass] during the

five-second beep.

• The red Armed LED flashes during the

exit-delay period.

• All zones normally armed by the

Arming Command Sequence are

armed except for the faulted zones.

If leaving, exit during the exit-

delay period.

RF3341 Keypad Any Arming Command

Sequence [9]

• The LED flashes indicating a signal

was sent to your security system.

• All zones normally armed by the

Arming Command Sequence are

armed except for the faulted zones.

If leaving, exit during the exit-

delay period.

RF3332/RF3332E,

RF3334/RF3334E

Not applicable

* Text Keypad only

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

Comments to this Manuals

No comments

Bosch DS7400XiV4-EXP User Manual Page 13

Comments to this Manuals

Related products and manuals for Security access control systems Bosch DS7400XiV4-EXP