Bosch DS7400XiV4-EXP User Manual download pdf (Page 28)

DS7400XiV4-EXP | User Guide | 10.0 Testing Your System EN | 28

Bosch Security Systems | 6/05 | 4998154961B

10.2 Battery Tests

If a power failure occurs, your control panel has a backup battery that continues to power the control panel for

many hours. The control panel automatically recharges the battery when power is restored.

In addition to the automatic battery test performed every 2 minutes, you can also test the battery manually. This

test also uses the battery to manually activate all the system sounders for 2 seconds ([PIN][#][8][5] only). If the

battery voltage is low, a battery fault occurs (refer to Section 9.0 Error Displays on page 25).

If you perform this test from a Master keypad, the keypad must be in Single Partition Mode. System Tests are not

available from RF (wireless) keypads.

Table 26: Zone Test

Type of Test Command Sequence What Happens What To Do

Local Battery/

Sounder Test

[PIN][#][8][5] • All keypad LEDs turn on.

• The keypad sounder and all alarm

sounding devices operate for 2 seconds.

• If the test fails, the control panel indicates

a control problem. Refer to Section 9.0

Error Displays on page 25.

• If the sounder fails to operate

or if the battery fails, contact

your installing company.

Battery Test [PIN][System Reset] • The control panel performs a battery test.

• The control panel reports a Low Battery

or a Low Battery Restoral is necessary.

• Contact your installing

company if a low or missing

battery is reported.

10.3 Communicator Test

This test is available only if your system sends alarms and system information to a monitoring service, and is

programmed by the installing company to permit communicator tests. You can perform this test from a Master

Keypad. The account code for Area #1 is used. System tests are not available from RF (wireless) keypads.

A long beep initially sounds to acknowledge the start of the test. If the test is successful, the sounder again sounds

one long beep. If the test fails, the keypad sounder turns ON continuously. To silence the sounder, enter your

[PIN] and press the [#] key or the [*] key.

Table 27: Communicator Test

Type of Test Command Sequence What Happens What To Do

Communicator

Test

[PIN][#][8][2]

• A long beep sounds.

• A “Test” report is sent to the monitoring

service.

• If the test fails, the keypad sounder

operates continuously.

To silence the sounder, press

[System Reset].

Note: This test can take several

minutes to complete because the

control panel attempts ten calls.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 39 40

Comments to this Manuals

No comments

Bosch DS7400XiV4-EXP User Manual Page 28

Comments to this Manuals

Related products and manuals for Security access control systems Bosch DS7400XiV4-EXP