Bosch DS7400XiV4-EXP User Manual download pdf (Page 7)

DS7400XiV4-EXP | User Guide | 6.0 Day to Day Operations EN | 7

Bosch Security Systems | 6/05 | 4998154961B

6.0 Day to Day Operations

6.1 Standard Operations

This section describes the standard (those built and programmed into your system at the factory) procedures for

arming and disarming your security system. Your installing company can program your system for various

optional operations (refer to Section 6.2 Optional Operations).

6.1.1 Normal Arming

Normal arming is used when no one is left on the premises, all zones must be armed, and an entry/exit delay is in

effect. The green Status LED must be lit and, if using a text keypad, “Ready to Arm” must be displayed. If the

green LED is not on or the keypad displays “Not Ready,” you must use other methods to arm the system (refer to

Section 6.2.2 Force Arming on page 13 or Section 6.2.3 Zone Bypass on page 14).

Table 3: Normal Arming

Equipment Command Sequence What Happens What To Do

Text Keypad

LED

Keypad

[PIN][On] • The red Armed LED flashes.

• “Armed” is displayed. *

• “Exit Now” is displayed during the exit-delay

period. *

• A single beep sounds.

• The red Armed LED lights steady when the

exit-delay period ends.

• All zones are armed.

Exit during the exit-delay period.

RF3341

Keypad

[PIN][#][1] • The LED flashes indicating a signal was

sent to your security system.

• All zones are armed.

Exit during the exit-delay period.

RF3332

RF3334

Press ARM button All zones are armed. Exit during the exit-delay period.

* Text Keypad only

1 2 3 4 5 6 7 8 9 10 11 12 ... 39 40

No comments

Bosch DS7400XiV4-EXP User Manual Page 7