Bosch CM10GD Use and Care Manual download pdf (Page 22)



17B@A:2;A@

'< .C<61 =<@@6/92 6;7B?F

16@0<;;20A =9B4 3?<: =<D2?

@<B?02 /23<?2 =2?3<?:6;4 .;F .@@2:/9F

.17B@A:2;A<??2=.6?

17B@A6;4H2C29&A<=

9.12HA<'./92

1. Pull up the bevel lock lever to loosen.

2. Loosen bolt heads “A” and “B” using a 10mm open

end wrench or socket (with socket wrench).

Loosen bolts at least one full turn (see Figure 23).

3. Loosen set screw “D” using the 4mm end of the

6/4mm hex key (provided with tool, but may also

use a standard 4mm hex key). Loosen screw at

least three full turns.

4. Place combination square on table and against

blade (see Figure 22).

5. Using the 4mm end of hex key, turn set screw “C”

and watch the saw blade tilt. Turn screw “C” until

the blade is aligned (full contact) with the square’s

body’s edge. After aligning, remove hex key.

6. Tighten set screw “D” using 4mm hex key.

7. Tighten bolt heads “A” and “B” using 10mm open

end wrench.

8. Adjust bevel scale pointers (item 36 – page 9) to

be in line with the bevel scale’s 0° lines.

9. Push down the bevel lock lever to lock.

*%""

H2C29&A<=J17B@A:2;A$?<021B?2

64B?2

Adjusting Bevel Stops

BM 2610027879 07-13_BM 2610027879 07-13.qxp 7/8/13 9:52 AM Page 22

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 163 164

No comments

Bosch CM10GD Use and Care Manual Page 22