Bosch CM10GD Use and Care Manual download pdf (Page 47)



NOTE: Position workpiece with its back flat on the

saw table.

Always place top edge of molding against fence

(decorative edge is at the bottom of crown molding.)

“Spring angle” refers to angle between wall and

crown molding.

Cutting crown molding flat on the table can be done

either as a chop cut or a slide cut depending on the

width of the workpiece.

Refer to special auxiliary fence for narrow cutoffs

when cutting crown flat on table (see page 48).

1. For 90° corner, set the bevel and miter angles

using charts below. Tighten the miter lock knob

and the bevel lock lever.

2. Position molding on saw table. Clamp workpiece

in place using the quick clamp.

(@209.:=6;4=<@6A6<;A5.A1<2@

;<A 6;A2?32?2 D6A5 <=2?.A6<;

23<?2@D6A056;4K#"L9<D2? 52.1 .@@2:/9F A<

:.82 @B?2 09.:= 092.?@ 4B.?1 .;1 52.1

.@@2:/9F

3. Follow procedures for either chop cut or slide cut

(see pages 34-35).

4. Wait until blade comes to a complete stop before

returning head assembly to the raised position

and/or removing workpiece.

NOTE: Always take a test cut using scrap to confirm

correct angles.

64B?2?<D;!<916;4 F6;49.A

*%""

Clamp

Miter Scale

Bevel Scale

Bottom Edge of

Crown Molding

Bevel Scale Settings Miter Scale Settings

For 45°

Spring Angle

For 45°

Spring Angle

For 38°

Spring Angle

For 38°

Spring Angle

33.9

35.3

31.6

&.D#=2?.A6<;@

?<D;!<916;4 F6;49.A<;'./92

!6A2?.;12C29&2AA6;4@3<?&A.;1.?1?<D;!<916;4BA@

*6A5!<916;49.A<;'./92@@B:=A6<;@Molding is milled consistently. Corner is exactly 90°.

Ceiling

45° Spring Angle

38° Spring Angle

52° 45°

38°

45°

Wall

Ceiling

Wall

45/45° Crown Molding

38/52° Crown Molding

Inside

Corner

Outside

Corner

Fence

Table

Top of Molding

Against Fence

BM 2610027879 07-13_BM 2610027879 07-13.qxp 7/8/13 9:52 AM Page 47

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 163 164

Comments to this Manuals

No comments

Bosch CM10GD Use and Care Manual Page 47

Comments to this Manuals

Related products and manuals for Mitre saws Bosch CM10GD