Bosch DS7400XiV4-EXP User Manual download pdf (Page 10)

DS7400XiV4-EXP | User Guide | 6.0 Day to Day Operations EN | 10

Bosch Security Systems | 6/05 | 4998154961B

6.1.4 Custom Arming

Custom arming is used to arm zones that you specify and your installer programs into your system. An entry/exit

delay is in effect unless otherwise programmed.

The green Status LED must be lit and, if using a text keypad, “Ready to Arm” must be displayed. If the green

LED is not on or the keypad displays “Not Ready,” you must use other methods to arm the system (refer to Section

6.2.2 Force Arming on page 13 or Section 6.2.3 Zone Bypass on page 14).

Table 6: Custom Arming

Equipment Command Sequence What Happens What To Do

Text Keypad LED

Keypad

[PIN][#][4] • The red Armed LED flashes.

• “On Partial” is displayed. *

• “Exit Now” is displayed during the exit-

delay period. *

• The green Status LED lights steady.

• A single beep sounds.

• The red Armed LED lights steady when

the exit-delay period ends.

• The zones that were programmed for

custom arming are armed.

Exit during the exit-delay

period.

RF3341 Keypad [PIN][#][4] • The LED flashes indicating a signal was

sent to your security system.

• The zones programmed for custom

arming are armed.

Exit during the exit-delay

period.

RF3332/RF3332E,

RF3334/RF3334E

Not applicable

* Text Keypad only

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

No comments

Bosch DS7400XiV4-EXP User Manual Page 10